Universal Remote Control RF20 manual Learning Method

15

Learning Method

BASIC SETUP

Learning Method

The RF20 can actually ‘learn’ commands from other remote controls (old or new), one-button-at-a-time, so it will never become obsolete. RF20 is the last remote you’ll ever need!

Just follow these simple steps:

STEP 1:

Line-up the RF20 with the other remote control, head- to-head, one or two inches apart.

STEP 2:

On the RF20, press and hold the MAIN and ENT (Enter) buttons at the same time for approximately three sec- onds, until the word “SETUP” is displayed at the top of the LCD screen. This signals you are now in SETUP mode.

IMPORTANT

You now have 30 seconds to perform the next step while you are in SETUP mode. If you don’t press a button within 30 seconds, SETUP will disappear from the screen, sig- naling that you have exited setup mode and you will need to start over.

MAIN

BUTTON

ENTER

BUTTON

STEP 3:

Press the LEARN display button on the LCD screen. The top of the screen will change to “LEARN” and display the five Components from Page 1 of the MAIN menu.

To display Page 2 of the MAIN menu that lists an additional five Components, simply press the PAGE ( ) ( ) buttons.

STEP 4:

Select the Component you want to teach commands to by pressing that Component display button on the LCD screen (in this example, TV). The top of the TV screen will change to “TV”.

NOTE: If you want to teach any command to a Component button, press the desired Component display button once the top of the screen dis- plays “MAIN”, by pressing the PAGE button. The top of the screen wil change to “READY”. Then go to STEP 6.

LEARN

BUTTON

16

Learning Method

BASIC SETUP