Universal Remote Control RF20 manual Basic Setup Overview, Pre-Programmed Code Method

7

Overview & Pre-Programmed Code Method

Basic Setup - Overview

There are two ways to program the RF20:

•The Pre-Programmed Code Method

•The Learning Method

The Pre-Programmed Code Method allows you to set up all the buttons at once, so it’s the fastest and easiest of the two methods. The Learning Method allows you to transfer functions from other remotes (old or new), one button at a time.

Pre-Programmed Code Method

8

Pre-Programmed Code Method

BASIC SETUP

STEP 1:

The pre-programmed 3-digit codes are found in the back of this Manual on page

45.The codes are listed by Component category (i.e., TV, VCR, DVD, etc.), then by brand name. For instance, if you want to locate a code for a Sony TV, first locate the TV category, and then look for the Sony brand.

Once you have located the 3-digit code (or in some cases, several code numbers) for the Component that you want to operate with your RF20, write them ALL down on a piece of note paper. It’s important that you write down all the codes because only one code is going to work for you.

STEP 2:

Now, turn on the Component you want to program... let’s say your TV to start. Look up your TV’s manufacturer setup code from your reference list.

STEP 3:

Press and hold the MAIN and ENT (Enter) but- tons at the same time for approximately 3 sec- onds, until the word “SETUP” is displayed at the top of the LCD screen. This signals that you are now in setup mode.

IMPORTANT:

You now have 30 seconds to perform the next step while you are in SETUP mode. If you don’t press a button within 30 seconds, SETUP will disappear from the screen, signaling that you have exited setup mode and you will need to start over.

MAIN

BUTTON

ENTER

BUTTON

BASIC SETUP