IF QUICK SET-UP DID NOT WORK, TRY THIS NEXT:
Three-Digit Code Set-Up Method
STEP 1: Find the 3-digit code numbers assigned to your brand from the lists in the back of this manual. The codes are listed by component category (i.e., TV, VCR, DVD, etc.), then by brand name. For instance, if you would like to locate a code for a Sony television, first locate the TV category and then look for the Sony brand.
STEP 2: Once you have located the 3-digit codes for each of the components that you wish to operate with your URC-A6, write them ALL down on a piece of paper. It’s important that you write down all the codes listed for your brand because only one code is going to work with your component.
STEP 3: Manually or using your old remote, turn on the component you want to program—for example, to program your TV turn on your TV set.
STEP 4: On the URC-A6, press the Component button that you want to program (in this case the button that says TV) and the SELECT [SEL] button at the same time. Hold down both buttons for 2 seconds until the TV Component LED light turns on. This signals that you are in programming mode.
IMPORTANT: You have 30 seconds to perform the next step while you are in programming mode. If you do not press a button within 30 seconds,the component LED light will turn off. The remote will exit the programming mode and you will have to start over.
COMPONENT
BUTTONS
SELECT
BUTTON