Toshiba TLP260 Correcting illuminated defects, With the document camera operating, fully, Imaging

Correcting illuminated defects

CONTENTS 60

Control panel (Main unit side)

							ON / STANDBY
						P	T	EMP
				ON		LAM			FAN
				TE					EXI
				EN	R				T
				U					A
									UT
				N					O	S
				E
				M						ET
										K
				T						E
										S
			U							Y
	N	P								T
I										O
										N
										E
							VOL / ADJ

2

Press both sides

Camera control panel

For the CCD image sensor used in the camera unit, in rare cases some of the pixels may be disturbed due to the influence of cosmic rays, etc. This disturbance may cause white spots to appear on the picture.

If white spots appear on the document camera image, use the procedure described below to correct the problem.

1	With the document camera operating, fully
	cover the camera lens with a piece of black

paper or cloth.

Camera lens

imaging

LOCK	W.BALANCE	ARM LIGHT
	CAMERA	CAMERA
	GAIN

2 ARM LIGHT

EXIT

Note

Press ARM LIGHT on the camera control panel and EXIT on the projector’s control panel simultaneously.

You can not use the remote control buttons.

cameraDocument

Do not press ARM LIGHT and EXIT buttons simultaneously if the camera lens is not covered. Doing so will not only erase the white spot correction data already set but also result in parts ot the image that are properly displayed being corrected. Also be careful if the camera input mode is not selected.