Toshiba TDP-MT200 Connecting the power cord, Removing the lens cover, Turning the power on

Page 21

English Français Español Deutsch Italiano Português Svenska

■Connecting the power cord

1Insert the power cord connector into the AC IN socket of the projector.

2Insert the power cord plug into a wall or other power outlet.

Power cord connector (Supplied)

■Removing the lens cover

Be sure to remove the lens cover when the power is turned on. If it is left on, it could become deformed due to heat.

Preparations

■ Turning the power on

1 Turn on the main power switch

The ON indicator will change to orange, indicating standby mode.

•After the main power switch is turned on, the inner cooling fan starts cooling.

(Orange)

2Press the ON/STANDBY button.

The power turns on, and the following 3 green indicators light: ON, LAMP, and FAN. After a moment, the start-up screen appears.

Remote	Start-up screen
Control panel Control

CAUTION

•Do not look into the lens while the lamp is on. The strong light from the lamp may cause damage to your eyes or sight.

•Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.

•Do not place your hands, face, or other objects near the air exhaust. Doing so could cause burns, deform/break the object.

21

Image 21

Contents TDP-MT200 USA only Safety PrecautionsBefore Using Power Sources Important Safety InstructionsSource of Light VentilationCleaning Power-Cord ProtectionHeat Water and MoistureImportant Safety Instructions Accessories Damage Requiring ServiceServicing Replacement Parts Safety CheckDo not use the product in a closed installation state Important Precautions Power Supply Cord SelectionPlace and Manner of Installation Save Original Packing MaterialsExemption Clauses Important Precautions Avoid Volatile LiquidOther Cautions and Informations Remote Control BatteriesContents Others Checking the package contents 108 11 Names of each part on the main unitNames of each part on the control panel and remote control Parts on the rear panel Loading dry-cell batteries into the remote control Preparing and using the remote controlOperating the remote control Remove the battery cover Insert the dry-cell batteriesPlacement Styles PlacementProjection Distance and Size Screen As seen from aboveBefore connection ConnectionConnecting the power cord Turning the power onRemoving the lens cover Turning the power off Turning the power on and offPress the ON/STANDBY button Press the ON/STANDBY button againBasic operations Turn on the powerActivate the connected device Press the Input buttonAdjusting the screen size and focus Projector placement angle adjustmentsTo adjust the horizontal angle, use the tilt adjuster Basic operationsUsing handy features Using auto settingCorrecting the keystone distortion Manual adjustments and settings Using handy featuresPress the remote control’s Freeze button Press the remote control’s Mute buttonCutting off the picture temporarily Mute Freezing the image FreezeHow to use the menus Using the menusImage adjustment menu Using the menu Display setting menuScreen size No signal Default setting menuSets the lamp power Low Standard AutoVersion Firmware version Note Displaying Information Status displayLamp replacement When the lamp is brokenAbout lamp Lamp replacement Lens cleaning Lens and main unit cleaningMain unit cleaning Replacing cooling fansPower went out during use No powerTrouble indications Lamp went out during use, or won’t come onBefore calling service personnel List of general specifications SpecificationsSpecification Separately sold productSVGA85 List of supported signals RGB signalsList of supported signals DVI signals SpecificationsList of supported signals Y/PB/PR signals List of supported signals Video, S-Video signalsPin assignment of Computer terminal Pin arrangement for the DVI-D terminal D V I D Control terminal Main CommandsPin assignment Interface format