Installation

Incoming Cable from Cable Company

75 Ohm VHF/UHF

on back of TV

ENGLISH

INSTALLATION

Television Location

This unit can be used as part of an entertainment center. Consult your dealer for available options.

•Avoid excessive sunlight or bright lights, including reflections.

•Keep away from excessive heat or moisture. Inadequate ventilation may cause internal component failure.

•Fluorescent lighting may reduce remote control transmitting range.

•Keep away from magnetic equipment, including motors, fans and external speakers.

Optional Cable Connections

Shielded audio and video cables should be used between components. For best results:

•Use 75-ohm coaxial shielded cables.

•Use appropriate input and output connectors, that match your component connectors.

•Avoid long cables to minimize interference.

AC Power Supply Cord

CAUTION: TO PREVENT ELECTRIC SHOCK,

MATCH WIDE BLADE OF PLUG TO WIDE SLOT

OF AC OUTLET AND FULLY INSERT. DO NOT Polarized plug

USE A PLUG WITH A RECEPTACLE OR OTHER

OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.

PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXIT FROM THE APPARATUS.

Cable / Antenna Connection

For proper reception, either a cable or antenna connection is required.

Cable Connection

Connect the cable supplied by your local cablecompany to ANT1 connection on back of television. Select cable mode and ANT1 in SET UP menu under Prog Chan (Program Channels).

Note: A cable converter box may be required for proper reception.

Check with your local cable company for compatibility requirements.

Antenna Connection

•	For proper reception of VHF/UHF channels, an
	external antenna is required. For best reception an
	outdoor antenna is recommended.
•	Connect home antenna to	Incoming Cable from
	ANT1 connection on back of	Home Antenna
	television. Select TV mode
	and ANT1 in the SET UP
	menu under Prog Chan.

Note: Cable Mode is preset at the factory. Antenna users must

change to TV Mode and ANT 1 in the Set Upmenu.

Auto Set Up Menu

For your convenience, Auto Set up menu will be displayed on screen when the set is turned on for the first time. If needed, follow the menus and procedures for setting up the features.

IDIOMA/LANGUE

To change menu language to ENGLISH, SPANISH or

FRENCH.

Procedure

•Press VOL u to select English, Spanish or French.

MODE

To select TV (antenna) or CABLE mode depending on the signal source.

Procedure

•Press VOL u to select TV or CABLE.

AUTO PROGRAM

To automatically program all channels with a signal.

Procedure

•Press VOL u to start Auto Programming.

CONVERGENCE

To adjust the center convergence, if needed.

Procedure

•Press VOL u to display center Convergence adjustment menu.

•Refer to page 27 for setting Convergence, if needed.

4•