Panasonic DMP-BD70V operating instructions Messages, On the television, Please confirm Setup

Page 38

Messages

The following messages or service numbers appear on the television or unit’s display when something unusual is detected during startup and use.

On the television

 

Page

 

 

 

Cannot play.

≥You inserted an incompatible disc (Discs recorded in PAL video, etc.).

6, 7

Cannot display on this unit.

≥You tried to play a non-compatible image.

7, 37

 

≥Confirm “SD” on the unit’s display is not blinking and re-insert the card.

No disc is inserted.

≥The disc may be upside down.

$ This operation is not

≥Some operations are unsupported by the unit. For example;

20

available.

[BD-V]: During playback, reverse slow-motion or reverse frame-by-frame is not possible.

 

$ This operation is

≥Depending on the disc, you may not be able to perform search or skip when film

20

prohibited by this disc.

previews and warning screens are being played back.

 

Cannot connect.

≥When a hub is used but its Link lamp does not light up, check the cable

16

Please check the

connection, LAN terminal connection, cable itself (a cross over cable may be

 

connection of the LAN

used by mistake), etc.

 

cable.

 

 

IP address is not set.

≥The “IP Address” in “IP Address/DNS Settings” is “---. ---. ---. ---”. Set the “IP

17

 

Address”, “Subnet Mask”, and “Default Gateway”. (Select the automatic address

 

 

acquisition if necessary.)

 

Cannot obtain IP address

≥If you use a hub, then check the connection between the hub and the router.

16

using DHCP.

–Use the UPLINK port of the hub to connect to a router.

 

Please check the

–Check whether or not the hub’s Link lamp lights up. If it does not light up, then

 

connection or router

check the cable connection, LAN terminal connection, cable itself (a cross over

 

settings.

cable may be used by mistake), etc.

 

 

 

 

≥If the above conditions are OK, then the router may not operate in DHCP mode.

16

 

Check the router settings and operation. You may reset the router to restore it to

 

 

normal.

 

This IP address is already in

≥This unit’s IP address is used by another device. Check the IP addresses of this

use.

unit, personal computers, and routers, etc. If necessary, reconfigure them to

 

Please check the IP address

avoid IP addresses from being duplicated.

 

setting.

 

 

Unable to perform

≥Turn the unit off. Remove the power cord and reconnect it and try again. If the

Connection Test.

same symptom persists, then consult your dealer.

 

Please try again.

 

 

IP address not set correctly.

 

 

Connection Test was

≥If you use a hub, then check the connection between the hub and the router.

16

unsuccessful. No reply

–Use the UPLINK port of the hub to connect to a router.

 

from host.

–If the hub’s Link lamp does not light up, then check the cable connection, LAN

 

Please check the

terminal connection, cable itself (a cross over cable may have been used by

 

connection or router

mistake), etc.

 

settings.

 

≥Check the “IP Address”, “Subnet Mask”, and “Default Gateway” in the “IP

17

 

 

Address/DNS Settings”.

 

 

≥If the MAC address information is required, then press [SETUP] to display the

17, 35

 

“Network” menu.

 

Network connection

≥When you set “BD-Live Internet Access” to “Allow (Limited)” and play BD-Live

32

refused.

contents which do not have a content owner certificate, the Internet access of the

 

Please confirm Setup

content is not allowed. If you allow the content to connect to Internet, set “BD-Live

 

“BD-Live Internet Access.”

Internet Access” to “Allow (ALL)”.

 

Unable to check for latest

≥The firmware download server is currently unavailable. Please try again later.

firmware version.

 

 

Please try again later.

 

 

 

 

 

38

RQT9412

Image 38
Contents If you have any questions contact CanadaThe warranty can be found onRegion management information Canada1-800-561-5505FCC Note Following Applies only in the U.S.AMedia handling MaintenanceUnit and media care To dispose or transfer this unitTable of contents Remote control Audio/Video Batteries AC power supply cord Accessory27informationUsing the remote control CableUser recorded media Media Disc/Card/USB device/Video cassette informationCommercially sold discs SD Memory Card* from 8 MB to 2 GB SD cardsDiscs that cannot be played in this unit Sdhc Memory Card from 4 GB to 32 GBEnjoying High Bit rate Audio of BD-Video BD-V Audio and video informationAbout audio from audio output terminals Regarding 24p output BD-V Necessary settings for audio outputAudio output setting for the various equipment To return to the previous screenVideo Connections TV Highest ConnectionsAbout terminal QualityConnecting to your TV, via Video OUT Connecting to your TV, via Hdmi AV OUTConnecting to your TV, via Component Video OUT Video Connections TVHdmi OUT Connecting to Hdmi AV OUT terminalDigital Audio Connections Audio AC power connectionAnalog Audio Connection Remote control and unit reference guide Power button Power Í/IPress Í Power SettingEasy Setting Reprogramming the remote control for TV controlAutomatically check the firmware Firmware updatesBroadband network connection Manually updating the firmwareSetting the IP address Network settingsTesting of IP Address/DNS Settings Setting the DNS-IPSetting the proxy server Setting the connection speedTesting of Proxy Server Settings Press 3, 4 to select Proxy Address and press OKInserting or removing an SD card Inserting or removing mediaInserting or removing a disc Inserting or removing a USB deviceBasic play Playing video contents Press 3, 4 to select the item Press OK Showing Functions menuPress Functions Press 3, 4, 2, 1 to select the title and press OK Chapter playback DVD-VRInsert a disc or SD card Insert a discEnjoying BD-Live discs with Internet Enjoying BD-Live or Bonusview in BD-Video BD-VPress PIP Insert an SD cardPress 3, 4, 2, 1 to select the album and press OK Playing still pictures JpegInsert a disc, SD card or USB device Press 3, 4, 2, 1 to select the still picture and press OKPress SUB Menu Press 3, 4 to select Zoom out Press OK Press 3, 4 to select Slideshow Settings and press OKPress 3, 4, 2, 1 to select Set and press OK Press Status twicePlaying a video cassette VHS Other operations of Video cassettePress 3, 4 to select the track Press OK Playing music CD MP3Insert a disc or USB device Playing a track in another folder MP3Preparation What is Viera Link Hdavi Control?Linked operations with the TV Viera LinkTM Hdavi ControlTM Select the player Easy control only with Viera remote controlPress the button for Viera Link on the remote control Press SUB MenuWhat you can change with the on-screen menu Changing settings with the on-screen menu except VHSOn-screen menu operations Audio PlayVideo BD-V Avchd DVD-VR DVD-V MPEG2Summary of settings Changing the unit’s settingsSetup menu operations Press 3, 4, 2, 1 to select the option and press OKTo select these options, perform steps 1-4 AudioDisplay TV / Device Connection Network Press 3, 4 to select the code 1, 2, or 3 To change the code on the remote controlCode and press OK OthersMP3 About MP3/JPEG filesStructure of folders that can be played in this unit On the television Please confirm SetupMessages On the unit’s display Power Troubleshooting guideTo reset this unit Following do not indicate a problem with this unitSound DisplaysTV screen and video USB CardOther difficulties with playback ≥This occurs between playlist chapters or scenes AvchdSpecifications Product Service User memoCarry-In or Mail-In Service Limited Warranty Only for U.S.A. and Puerto RicoCentralized Factory Service Center Limited Warranty Limits And ExclusionsIf YOU Ship the Product to a Servicentre Limited Warranty Only for CanadaWarranty Service Panasonic Canada IncLicenses Conexiones básicas Reproducción básicaDTS-HD GlossaryBD-J Viera Cast Quick Start R Ratings level Re-master Remote control AC Power Connection Angle AudioOff Timer On-screen Connections