Lexicon BD-30 manual Setting the Remote Code

Installation Lexicon

Setting the Remote Code

The remote control supports one of three remote codes. The default is “Code 1”. If you have other Lexicon products placed close to the BD-30, they may inadvertently respond to the BD-30 remote control. In this case you can select a different remote code to avoid conflicts.

To select a new remote code, open the battery compartment cover of the remote control, and then use a ballpoint pen to flip the switch to one of the positions marked as “1”, “2”, or “3”. Close the battery compartment cover. Make sure that the BD-30 player is turned on and the disc tray is ejected. Aim the remote control at the player. Press and hold the ENTER button for 5 seconds. The player will start using the new remote code.

Battery Compartment

Remote Code Switch

Cautions

•Never drop the remote control or expose it to moisture.

•Never expose the infrared remote sensor on the front panel to direct sunlight or other strong light sources.

•Remote may not operate consistently when batteries become low. Replace them if operation deteriorates.

•If the remote control will not be used for a long time, please remove the batteries.

•Use the batteries correctly to avoid possible leakage and corrosion. Do not leave the batteries exposed to direct sunlight or high- temperature environment for a long period of time. Do not heat or expose to flame. Do not mix old and new batteries. Do not use batteries of different types at the same time. Do not attempt to recharge the batteries.

•In case battery leakage occurs, do not touch the liquid with bare hands. Wipe out any liquid inside the battery compartment, and insert new batteries.

12