Setup Menu Options | |
|
|
Speaker Settings
For each speaker in the home theater system, you can set its size, distance and trim level. To configure a speaker, move the cursor to highlight the speaker and press the ENTER button. The Speaker Settings menu on the right side of the screen will be activated. In the Speaker Settings menu, use the UP/DOWN ARROW buttons to select a parameter, and then press the ENTER button to change it. To exit the Speaker Settings menu and return to the Speaker Configuration illustration, press the LEFT ARROW button or select the “Exit” option. You can also move on to configure the next speaker by selecting the “Next Speaker” option.
Speaker Configuration
FL | C | FR |
|
| Down Mix |
|
|
| |||
| SW |
|
|
| LT/RT |
SL |
|
| SR |
| |
|
|
|
| ||
|
|
|
|
| Stereo |
SBL |
|
|
| SBR | 5.1Ch |
|
|
|
| ||
|
|
|
|
| 7.1Ch |
Down Mix Mode: 7.1Ch
Choose down mix mode
Exit
The following speaker parameters can be configured:
1.Size: The speaker size parameter sets bass filtering control for the speakers. The bass crossover frequency is fixed at 80Hz. The options are:
• Large – Bass frequencies are passed to the speakers.
•Small – Bass frequencies are not passed to the speakers to reduce possible distortion. If the subwoofer is available, bass frequencies are redirected to the subwoofer.
•On (for subwoofer only) – Specify that a subwoofer is available.
•Off – Speaker for the corresponding position does not exist. Audio for the missing speaker is redirected to other speakers or discarded if redirection is not possible.
Note
The front, surround and surround back speakers are configured as pairs. Changes to the size of one speaker will automatically change the other speaker of the pair.
2.Distance: The speaker distance parameter sets delay control for the corresponding audio channel. The delay is to compensate for the audio propagation time difference caused by the placement of speakers.
Speaker distance compensation is not required if the A/V receiver or processor has the capability to adjust channel delay and compensate for speaker distance differences. However, if your receiver does not have such functions (most receivers do not offer these functions for their
Since the delay is calculated based on the distance difference from each speaker to the listener’s position, it is important to set the distance for the front speakers first and then
the other speakers. Anytime you change the distance of the front speakers, the distance of the other speakers will be automatically adjusted to maintain the same distance difference.
65