References | Lexicon |
|
|
Useful Notes
•In order to prolong the service life of your player, it is recommended to wait at least 30 seconds before you turn it on again after switching it off.
•Remove disc and turn power off after operation.
•Some functions of the player may not be applicable to certain discs.
•Some discs with special features may not be fully supported by the player. This is not a malfunction of the unit.
•In case of player malfunction, please turn it off, wait for 30 seconds and turn it back on. If the problem still exists, please follow the troubleshooting instructions or contact a Lexicon service center.
Troubleshooting
Use this chart to resolve general operational problems. If there are any problems that you cannot resolve, please contact your Lexicon service center.
|
|
| Reference |
Symptom | Possible Cause | Solution | Page |
|
|
|
|
No sound | Audio cable is not properly connected | Check audio cable, and then reconnect if necessary. | 13 - 19 |
|
|
|
|
| Mute is activated | Press the MUTE button to cancel the mute. | 30 |
|
|
|
|
| Volume is too low | Press the VOL + button to increase the volume to 100. | 30 |
|
|
|
|
| SACD is played and the audio connection is coaxial or optical | This is not supported due to copyright restrictions of SACD. | 18, 53 |
| digital audio | Please use the analog or HDMI audio output. Alternatively, you |
|
|
| may set SACD Priority to CD mode and the player will play the CD |
|
|
| layer. |
|
|
|
|
|
| This is not supported due to copyright restrictions of SACD. | 18, 53 | |
| optical digital audio | Please use the analog or HDMI audio output. Alternatively, you |
|
|
| may switch to the |
|
|
|
|
|
No picture | Video cable is not properly connected | Check video cable; reconnect if necessary. | 13 - 14 |
|
|
|
|
| TV input is not correctly selected | Select the input to which the player is connected. |
|
|
|
|
|
| “Pure” mode engaged | Check the “PURE” display on the front panel, and press the PURE | 44 |
|
| button to cancel this mode. |
|
|
|
|
|
| Video output format is not support by the TV | Select a proper output resolution that is supported by your TV. | 35 |
|
|
|
|
| Video system is not supported by the TV | When playback is completely stopped, press the P/N button or set | 35, 54 |
|
| the correct TV System in the Setup Menu. |
|
|
|
|
|
74