Lexicon BD-30 manual Zooming and Aspect Ratio Control, Zoom Levels for Hdmi Output

Page 39

BD-30 Blu-ray Disc Player

NTSC output via component:

1080p 60Hz* → 1080i 60Hz → 720p 60Hz → 480p → 480i

PAL output via component:

1080p 50Hz* → 1080i 50Hz → 720p 50Hz → 576p → 576i

*When 1080p is selected for the component output, HDMI output resolution will be 1080p and component output resolution will be 1080i.

Note

•Some TV sets do not support one or more output resolutions (particularly 1080p). If an incompatible output resolution is selected, you will get a blank screen or an error message. In this case please select an output resolution that is supported by the TV.

•In case you are not able to get a picture using the HDMI or component output, please connect the player to the TV using the composite video output, then use the Setup Menu to adjust the player settings.

•Video up-conversion over the component output is only available for unencrypted discs such as home video and consumer-created contents. Most commercially pressed DVD discs are CSS-encrypted and will be limited to 480i/480p resolution. This restriction applies to the component output only. The HDMI output is protected with HDCP and has no such restriction.

Zooming and Aspect Ratio Control

This feature zooms in or out of the displayed frame and also

ZOOM changes the aspect ratio (image

width vs. height).

To change the zoom level, press the ZOOM button on the remote

control. Each press of the ZOOM button will switch the zoom level in sequence.

Zoom Levels for HDMI Output

The following zoom levels are available when “Primary Output” is set to “HDMI”:

1:1 (No zooming) → Stretch/Letterbox/Pillar Box → Full Screen

→Under Scan → 1.2 → 1.3 → 1.5 → 2.0 → ½ → Back to 1:1 again

The zoom level is reset to 1:1 when the disc is ejected, or when the player is turned off.

The available zoom levels depend on the “TV Aspect Ratio” setting in the Setup Menu and the aspect ratio of the DVD or Blu-ray Disc. The following zoom levels may be useful for some special applications:

1)Playing 16:9 BD or DVD when “TV Aspect Ratio” is set to “16:9 Wide” or “16:9 Wide/Auto”

•Stretch – The image is vertically stretched by 1.33 times. For movies with 2.35:1 aspect ratio, this zoom level cuts off the black borders at the top and bottom of the image. Users of projector with anamorphic lens may find this mode helpful.

Original 2.35:1

 

Widescreen Movie

“Stretch” Zoom

Projected through an Anamorphic Lens

35

Page 38 Page 40
Image 39
Page 38 Page 40
Contents BD-30 Blu-ray Disc Player Page Table of Contents Table of Contents Important Information Important Information Important Safety InstructionsPrecautions FCC StatementTrademarks Compatible Disc Types Discs that cannot be playedDisc care and handling Copyright Protection Region management informationTHX Certified Blu-ray Disc Player Page Installation Front Panel Display Window Front Panel ControlsInstallation Rear Panel ConnectorsRemote Control Buttons Remote ControlBattery Installation Using the Remote ControlBack Side Setting the Remote Code Hdmi Connection Connecting to a DisplayDVI Connection Component Video Connection Connecting to a Receiver/Amplifier with Hdmi Input/Output Connecting to an Audio SystemReceiver/Processor with 7.1ch Audio Input Receiver/Processor with Dolby Digital or DTS Decoder Connecting to a Stereo Audio System Connecting to the Internet External IR Infrared Remote Installation Custom InstallationSetting Up the Player Easy Setup Wizard Access the Easy Setup WizardChoose the Primary Video Output Content Source Direct Output Resolution Select the Best Output ResolutionDetermine the Display Aspect Ratio Getting StartedPicture Complete the Easy Setup Wizard Select the Audio SettingBasic Operations Pause and Frame-by-Frame Disc PlaybackBlu-ray Disc Menu Playback On-Screen DisplayDVD Menu Playback Volume Control Audio Language/Track Selection Subtitle SelectionMute Picture-in-Picture and Secondary Audio Angle SelectionBD-Live Advanced Operations TV System Selection Output ResolutionZoom Levels for Hdmi Output Zooming and Aspect Ratio ControlOriginal Widescreen Movie Full Screen Zoom Pillar Box ZoomLetterbox Zoom Advanced OperationsZoom Levels for Component Video Output Advanced OperationsFast Playback Repeat a Selected SectionRepeat Playback DVD and Blu-ray Discs Shuffle and Random PlaybackPlayback from a Specific Location Playback by Chapter or Track NumberCD and Sacd discs Memory and Automatic Resume Pure Audio ModeMedia File Playback Home Menu Playback from a USB DriveMusic Playing Music FilesViewing Photo Files Playing Movie FilesSkip PREV/NEXT Adding Background MusicPage Setup Menu Options Setup Menu Section Menu Item Selection Using the Setup Menu SystemSetup Menu Options Language Playback SetupNtsc Video SetupSetup Menu Options Setup Menu Options Setup Menu Options Picture Adjustment Setup Menu Options Audio Format Setup Setup Menu Options Output Audio Signal Reference ChartRecommended Audio Format Options Audio Connection Directly to TVMulti-Channel Analog Audio to Receiver or Processor Stereo Analog Audio to Receiver Audio Processing SetupSpeaker Configuration Coaxial or Optical Digital Audio to Receiver or ProcessorDown Mix Mode Speaker ConfigurationSpeaker Settings SBL SBR Unsupported Configuration Settings Other Audio Processing SettingsHdmi CEC Device SetupSetup Menu Options Network Setup Setup Menu Options Page References Reference TroubleshootingSymptom Possible Cause Solution Useful NotesReferences Specifications Code Language Name Language Code ListFirmware Updates Appendix Lexicon BD-30 Blu-ray Disc Player RS-232 Control Protocol RS-232 Pin ConfigurationCommunication Settings Command StructureCommand Sequence Command ListCommand that maps to a remote control button NU3 Command Code Function Response Example Query CommandsCommand Code Parameters Function Possible Response Advanced CommandsAppendix Appendix Appendix Xxxxxxx
Top Page Image Contents