Samsung 870D, 1670D, SRD-850D, SRD-830D, SRD-1650D Setting the Motion Detection Area

using the DVR

~Alarm : Sets the alarm output method.

`For further information on alarm output, refer to “HDD Alarm > Alarm”. (Page 49)

~Duration : Sets the duration of alarm signal and alarm sound.

5.When the sensor detection setup is done, press <OK>.

Motion Detection

Sensor Detection
Sensor	Sensor Operation 		Cam 			Alarm 		Duration 
1	OFF			1		None		10 sec	
2	OFF			2		None		10 sec	
3	Alarm Setup								
4	OFF			4		None		10 sec	
5	OFF	1 		5	2	None	3	10 sec	
6	OFF	4 		6	BEEP	None	All	10 sec	
7	OFF		OK	7		None		10 sec	
8	OFF			8	Cancel			10 sec	
						None
							Previous/Next Page
			OK		Cancel

You can set target detection region and motion, as well as the alarm signal output. When the motion detection region is set, it detects motion within the area.

Using the mouse may help make setup easier.

3.Use the up/down buttons (▲▼) in <Event> window to move to <Motion Detection>, and press [ENTER] button. A window of motion detection area setup appears.

4.Use direction buttons (▲▼_ +) to move to a desired item, and set the value.

~Mode : Sets whether to activate motion detection.

~Sensitivity : Sets the sensitivity level of the motion detection.

~Alarm : Sets the alarm output method.

`For further information on alarm output, refer to “HDD Alarm > Alarm”. (Page 49)

~Alarm Duration : Sets the duration of alarm signal and alarm sound.

5.When the motion detection setup is done, press <OK>.

Motion Detection

CH	Mode 		Sensitivity 		Alarm 	Alarm Duration 
1	OFF		Very High		None	10 sec	
2	OFF		Very High		None	10 sec	
3	OFF		Very High		None	10 sec	
4	OFF		Very High		None	10 sec	
5	OFF		Very High		None	10 sec	
6	OFF		Very High		None	10 sec	
7	OFF		Very High		None	10 sec	
8	OFF		Very High		None	10 sec	
						Previous/Next Page
						Motion Region
			OK		Cancel

Setting the Motion Detection Area
 Select <Motion Region>.
 When “Motion Region” window appears, select a
channel for detection and set the area of motion
detection.
~ To set the area in “Motion Region” window
In the “Motion Region” window, select desired region
from <	>.
			Motion	Region
			1 CH
~ To set the area using <Individual> selection
						Indi	vidua	l	Appl	y to All CH
In the “Motion Region” window, you can select cells
					OK	Cancel
individually by using <Individual>.
When selected <Individual>, “Motion Region” window
		disappears and you can select cells one by one.
When the motion area setup is done, press the <Menu> on the screen or the [MENU] button on the
remote control or front panel to display the “Motion Region” window again.

-Select : Selected cell is set to be a part of motion detection area.

-Unselect : Selected cell is removed from the motion detection area.

-Inverse : Unselected cells are set to be the motion detection area.

-Menu : After selecting individual motion areas, move to the “Motion Region” window.

`If selected <Apply to All CH>, selected motion area is applied to all channels.

When the motion detection setup is done, press <OK>.

Select

Unselect

Inverse

Menu

58_ using the DVR