Configuration Procedure | 19 |
2Add the phone number of the other site (Office B) to the dial number list.
a In the Dial on Demand Dynamic Dial section of the navigation frame, click the PORT DialNoList link.
b In the start field, choose 4.
c In the DialNoList field, enter the phone number in quotes of the remote site in the DialNoList field. For example, enter:
"4085551212" T=BRI B=64
dClick Apply.
If you wish to use both BRI channels on this port, you must specify a second phone number in the dial number list.
eIn the start field, choose 4.
fIn the DialNoList field, enter the second phone number in quotes of the remote site. For example, enter:
"4085551212." T=BRI B=64
The “.” in the phone number entry above allows you to enter the same number in both places.
gClick Apply.
3Set the port to dial on demand.
a In the Dial on Demand Dynamic Dial section of the navigation frame, click the PORT DialInitState link.
b In the start field, choose 4.
c In the DialInitState field, choose DialOnDemand. d Click Apply.
4Enable multilink protocol control on the port.
a In the Dial on Demand Dynamic Dial section of the navigation frame, click the PPP MlpCONTrol link.
b In the start field, choose 4.
c In the MlpCONTrol field, choose Enabled. d Click Apply.