12CONFIGURING YOUR OFFICECONNECT NETBUILDER 10 BRIDGE/ROUTER
Configuration Procedure
This section provides step by step instructions for configuring the set up shown in Figure 5.
Figure 5 Office A Configuration
Network management system
|
| Office A |
IP 10.1.0.0 |
| IPX = AAA |
|
| |
OfficeConnect |
|
|
bridge/router |
|
|
|
| Leased line |
|
| IPX = CCC |
ISDN |
| IP = unnumbered |
|
| |
|
| OfficeConnect |
| ISDN | bridge/router |
ISP |
| |
|
| |
Internet |
|
|
| IP 20.1.0.0 | Office B |
|
| IPX = BBB |
Network management system
In these instructions, your site is Office A.
To configure your OfficeConnect NETBuilder 10 bridge/router, follow the steps in the following sections:
■Configuring ISDN Lines:
■If you are located in North America, use the procedure in “Configuring ISDN (In North America)” on page 13.
■If you are located outside North America, use the procedure in “Configuring ISDN (Outside North America)” on page 16.