Preconfiguration Set Up | 9 |
No leased line configuration is required. The OfficeConnect NETBuilder 10 bridge/router automatically configures the
PPPconnection when power to the bridge/router is turned
on.
Cable the ISDN Port
Plug the
ISDN connections to an OfficeConnect bridge/router used in the U.S. and Canada also require a network termination (NT1) device and power supply. These can be leased from the telephone company or purchased from an ISDN equipment vendor. In other countries, you do not need to provide this equipment because the function of the equipment is provided by the ISDN equipment at your site.
Turn on Power to the OfficeConnect
Attach the power cord to the power receptacle on the back panel. This receptacle is labeled with the electrical rating for the power adapter included with your OfficeConnect bridge/router.
The OfficeConnect bridge/router does not have a power switch.
To turn power on, plug the other end of the power cord into an electrical outlet.
CAUTION: Make certain you plug the OfficeConnect bridge/router into an easily accessible electrical outlet located near the unit.
Wait for all the LEDs to turn green. When the LEDs are green you are ready to continue.
To turn off power or to reset the bridge/router, unplug the power cord from the outlet.
Restart the NMS DHCP Client
When you restart the PC, the NMS DHCP client (your PC) acquires an IP address from the OfficeConnect bridge/router DHCP server, which is enabled by default.