Universal Electronics 4-DEVICE Universal Remote Control manual Tv/Vcr

Page 10

PROGRAMMING TV/VCR COMBO CONTROL

3. (continued)

NOTE: If the VCR key did not blink twice after enter- ing the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.

If you’ve located a TV/VCR setup code that works your TV/VCR Combo and a separate TV code is also listed, you’ll need to program this code into the remote control to access volume control (see Programming Device Control on page 8).

4. Aim the remote control at your TV/VCR Combo and press POWER once. The device should turn off. If it does not respond, repeat steps 2-3 (starting on the previous page), trying each code listed for your brand until you find one that works. If it still does not work, try searching for the code (see Searching For Your Code on page 20).

5.For future reference, write down each working device code in the boxes below:

TV/VCR

TV (if used)

10

Image 10

Contents Atlas Cable 4-DEVICE Table of Contents Introduction Code library for popular video and audio devicesFeatures and Functions Use Setup for all programming sequences Key ChartsUse Guide to display the program guide Press Mute once to turn the sound off or on Use CH+ or CH- to select the next higher or lower channelInstalling Batteries Installing Batteries Programming Device ControlAUD TV/VCR Setup Codes for Audio Receivers Setup Codes for Audio AmplifiersMANUFACTURER’S Codes ABC Setup Codes for Cable ConvertersSetup Codes for DVD Players GPXSetup Codes for VCRs and PVRs CCEKLH HI-QKEC LXISTS NECTMK AOC Setup Codes for TVsCXC NAD JCBKTV NTCSSS Setup Codes for TV/VCR Combos Press Setup once to lock in the code Searching for Your CodeChecking the Codes Enter 9 8 2. The CBL key will blink four times Programming ID LockTurn on the cable converter Enter 9 8 2. The CBL key will blink twiceProgramming Channel Control Lock Enter 9 7 Press CH- once. The CBL key will blink four timesTo Operate The Master Power Key To Program The Master Power KeyTo Clear The Master Power Key Perform steps 1 and 2 in the above section Press Power onceRE-ASSIGNING Device Keys TV VCRUsing Macros Example Programming a Favorite ChannelTo Clear a Macro Changing Volume Lock To Unlock All Volume Control Global Volume UnlockTo Lock Volume Control To One Mode Global Volume Lock Problem TroubleshootingSolution Additional Information M4030 04/02