CHECKING THE CODES
If you have set up the Atlas Universal Remote Control using the Searching For Your Code procedure (on the previous page), you may need to find out which
1. 
On the remote control, press TV once. Then press and hold SETUP until the TV key blinks twice, then release SETUP.
2. 
Enter 9 - 9 - 0. The TV key will blink twice.
3. 
To view the code for the first digit, press 1 once. Wait 3 seconds and count the number of times the TV key blinks (e.g., 3 blinks = 3) and write down the number in the leftmost TV Code box (see below).
NOTE: If a code digit is “0”, the selected mode key will not blink.
4.Repeat step 3 three more times for remaining
digits. Use 2 for the second digit, 3 for the third digit, and 4 for the fourth digit. Finish writing down the code in the TV Code boxes below.
5.To check for other device codes, repeat steps 1 through 4, but substitute the appropriate key (i.e., AUD, VCR, or CABLE) for the (Audio,VCR, or Cable) device you are checking. Write down the codes in the appropriate boxes below.
AUD Code
Audio Device ____________________
VCR Code
TV Code
CABLE Code
21