PROGRAMMING ID LOCK
The Atlas Universal Remote Control is preprogrammed and locked at the factory to operate a Scientific Atlanta cable converter.
However, if you have another brand or model of cable converter and interactive service that you would like to control, then you’ll need to perform the following steps to unlock the cable ID Lock, enter in a new manufacturer’s code, and lock the ID Lock again.
1.Turn on the cable converter.
2. 
On the remote control, press CBL once. Then press and hold SETUP until the CBL key blinks twice, then release SETUP.
3. 
Enter 9 - 8 - 2. The CBL key will blink four times.
4.Perform the instructions in Programming Device Control on page 8 to program device control for the desired cable converter and interactive service. Upon completion, perform the remaining steps (5 and 6 on this page) to again lock the ID lock.
5. 
On the remote control, press CBL once. Then press and hold SETUP until the CBL key blinks twice, then release SETUP.
6. 
Enter 9 - 8 - 2. The CBL key will blink twice.
22