Chapter 3: Programming
combinations is incorporated into a phone number, it is counted as one digit toward the total of 32 digits allowed per dial out phone number.
Dialing to a Beeper or Pager
The following example demonstrates just one solution to program- ming the Boat Remote for dialing to a beeper or pager. Many other key sequences will also work. Start with steps
1.Press SET.
2.Press PHONE NUMBER.
3.Press any unassigned number key (from 1 to 8) to represent the new telephone number entry.
4.Enter the complete telephone number using the number keys.
5.Press CODE + 1. This instructs the unit to wait for the telephone call to be answered by the beeper or pager service.
6.Now press CODE + 2 to activate a two second pause. This assumes the call is answered by a beeper/pager service that immediately delivers a prerecorded voice message. The PAUSE special code may be entered more than once to program more time for the beeper/pager service to finish its message. Each entry of the PAUSE special code allocates two additional seconds. The Boat Remote will “beep” with each entry.
7.Enter a telephone number or custom code number that will identify the Boat Remote as the caller to your beeper or pager. A code may consist of any number(s) you designate. Many users find it convenient to use the telephone number to which the Boat Remote is connected.
8.A pound may be required in some dialing situations. If required, position the pound (#) within the telephone number where required by pressing the pound special code, CODE + 4. The unit will “beep” each time the pound (#) special code is entered.
10.Press ENTER. Example
16105581212WPP3116655#
41