Boat Remote User’s Manual
Bilge Pump Inputs (2)
The Bilge Pump Inputs will monitor the number of on/off cycles and the accumulated run time of your bilge pumps. The alarm param- eters can be programmed to detect whether the bilge pump runs too frequently (cycle rate alarm) or for too long a period (maximum run time alarm). To aid in determining the appropriate alarm parameters for your boat, set the input mode to status only and monitor the display for a day or so. It will show bilge pump activity as follows:
Bilge Pump 1 | OFF | |
Cycle: 0 | Time:0:00 | |
Max | Cycle Rate: | 0 |
Max | Runtime: | 0:00 |
1.The real time status, on or off, of the bilge pump.
2.Number of cycles and accumulated run time over a 24 hour period starting at 12 am. (This resets to 0 at 12 am)
3.Maximum # of cycles over the programmed cycle rate alarm period.
4.Maximum run time of any one cycle.
To program the bilge pump alarm parameters:
Press SET.
Press BILGE #1 or BILGE #2.
or
The input mode will be displayed. Press the MODE key on the keypad until the appropriate mode is shown on the display. The default for bilge #1 is active. The default for bilge #2 is off. Press ENTER.
Press the MODE key to toggle through the three input modes.
Press ENTER.
50