Phonetics Boat Remote user manual Status Report

Chapter 4: Operation

until the alarm is acknowledged. Since Boat Remote is in On-Board Mode, an alarm dial out will not occur. The red warning LED will continue to blink and the alarm condition will continue to be dis- played on the LCD screen.

Acknowledgment

1)The unit is operating in On-Board mode, so you must acknowl- edge the alarm by pressing any key on the Boat Remote keypad. The unit will beep and the red LED will change from blinking red to steady red if the alarm condition still exists. If the alarm condition has been corrected, the red LED will go from blinking red to off.

STATUS REPORT

The status report function allows you to call in to Boat Remote and check the status of all monitored conditions. The unit will answer an incoming call after the programmed number of rings until answer. If any alarm conditions exist, the alarm message will be recited. For information on an input to be included in the status report, that input’s mode must be set to either “active” or “status-only”.

The following is an example of what Boat Remote will recite during a status report if all inputs are activated.

“Hello,

This is the King Crimson docked at the Big Fish Marina, slip number 21. (recorded ID message)

or: This is Boat Remote. (default ID message)

Bilge Pump 1 cycled 4 times today for a total of 7 minutes 46 seconds.

Bilge Pump 2 cycled 3 times today for a total of 6 minutes 23 seconds.

The battery voltage is 13.7 volts. (current battery voltage)

The AC power is ON. (Other response: OFF)

The cabin temperature (recorded message for Temp #1 input) is 65.4 degrees Fahrenheit/Celsius.

or Temperature #1(default voice message for Temp #1 input) is 65.4 degrees Fahrenheit/Celsius.

Engine room temperature (recorded message for Temp #2 input) is

71