Boat Remote User’s Manual
“Indicate you have received warning message.”
6)The answering machine can’t enter the acknowledgment code, so after 10 seconds Boat Remote will say:
“Error.”
7)The unit hangs up.
8)Boat Remote waits 2 minutes (programmed Intercall Delay time) then dials the next number on the dialout selection list (phone #4, your primary residence,
9)The call is answered.
10)Boat Remote recites the following message 3 times (pro- grammed number of voice repetitions)
“Hello, this is (Boat Remote ID Message).
“Bilge Pump #1 cycle rate exceeded. 5 cycles in the last 24 hours.”
11) After the third repetition, the unit will request acknowledgment:
“Indicate you have received warning message.”
Acknowledgment
1) You enter the ‘555’ acknowledgment code. The unit then says:
“Alarm acknowledged”
2)The unit will then hang up. The alarm has been acknowledged and the dialout sequence stopped.
NOTE: Boat Remote will not dial out again for a Bilge Pump #1 alarm unless the input returns to its normal state and then is tripped again.
EXAMPLE 2 (Away Mode: voice dialout & acknowledgment)
Alarm Recognition
Your boat’s slow leak has suddenly become a serious leak and the bilge pumps can’t keep up with the incoming flow of water. The rising water trips a float switch wired to the High Water input of your Boat Remote. The float switch remains closed for 1 minute (the programmed alarm recognition time) and the High Water input is set to “Active” so Boat Remote enters the Alarm Notification sequence.
Alarm Notification
1) Boat Remote waits 30 seconds (the programmed Call Delay
68