Evolve Communications RD5000 Select key. repeat step, To test the next code, Access the Extended

Getting Started

7	To test codes, point the
	remote towards	the	device
	and press keys	like

“POWER”, “VOL”, “CHAN”, etc. Or, to access keys such as “PLAY”, “STOP”, “SLEEP”, etc. see the first note below.

	If the keys respond, highlight
	Yes and press the SELECT
	key, then go to step 8.
	If the keys do not respond,
	highlight No and press the
	SELECT key. (repeat step 7
	to test the next code)
	If the keys you want to test
	are not on the remote,
	access the Extended
	Function Screen by pressing
	the ADVANCED key and
	follow step 7b.
Note	Most devices can be tested using the “hard” keys on the remote like
	“POWER”, “VOL”, “CHAN” etc. However, depending on the device, such as
	stereo receivers, CD players, digital tape players, etc., you may be required
	to access the Extended Function Screen because the hard keys are not on
	the remote (i.e. Play, Stop, Menu, Contrast, etc.). (see step 7b)
Note	There is a possibility that more than one code will work when setting up your
	device. After you have completed setup, if you cannot find a function in
	the Extended Function Screens, remove the device and try setting up the
	device again using a different code.

*Trademark Setup Remote Control 17