Fortinet 2 SXRC manual Reconnect cables, Between each step, Please read, Instructions and follow

5-Meter Network Cable

AMP STRAPPING

IN OUT

1-Meter Network Cable

AMP STRAPPING

IN OUT

1-Meter Network Cable

AMP STRAPPING

IN OUT

Installation

Software Updates

Now that you have the SXRC mounted and wired properly it is time to update the software in all of your SX Series amplifiers. This process has to be completed for EACH amplifier and does

require you to disconnect				Communication
	Interface Box Network Jack (RJ45)
and reconnect cables
	SXRC TO
				Power, Ground
between each step.
				Remote Jack
Please read the
		+ 12	V M	ND
	FROM AMP		RE G		Ground
instructions and follow				HyperFlex
				HyperFlex	Remote
them exactly as				HyperFlex	5	+12 Volt
					Fuse

described.

NOTE!!!

Each SX Series amplifier must be assigned its own unique address from the amplifier’s keypad before it can be updated and controlled by the SXRC. This has to be done at each amplifier’s keypad and can not be done from the SXRC. Think of the amplifiers like houses...no two houses can share the same street address...the mailman would throw a complete fit! Well, the SXRC feels the same way about two amps sharing the same Remote Communication Address.

Each series of SX amplifiers (.2-Stereo, .1-Mono Block, .4-Four Channel) has a unique address range that is not shared between the others. So it is impossible to accidentally share addresses

You only have to do this setup and programming process one time for each amplifier.

Step 1.) Un-plug the Communications Network Cables from the REMOTE OUT jacks on ALL the SX Series amplifiers. Leave the Communications Network Cables connected to the REMOTE IN jacks. The SXRC Interface Box should only be connected to the first SX Series amplifier as the diagram to the right is showing.

IN OUT

IN OUT

IN OUT

Additional Network Cable

(Supplied By You)

from one series with another. All you need to do is assign a unique (different) address to each amplifier in you system. The possible choices for each series are:

SX.2 Series - Addresses 10-59

SX.1 Series - Addresses 60-109

SX.4 Series - Addresses 110-119

All SX Series amplifiers are shipped from the factory with their Remote Address set to the lowest setting.

SX.2 Series - Address 10

SX.1 Series - Address 60

SX.4 Series - Address 110

For example, lets say you have 4 SX.2, 4 SX.4 and 4 SX.1 amplifiers in your system for a grand total of 16 amplifiers. Set the Remote Addresses as such:

SX.2 # 1	- 10	SX.1 # 1 - 60	SX.4 # 1	- 110
SX.2 # 2	- 11	SX.1 # 2 - 61	SX.4 # 2	- 111
SX.2 # 3	- 12	SX.1 # 3 - 62	SX.4 # 3	- 112
SX.2 # 4	- 13	SX.1 # 4 - 63	SX.4 # 4	- 113

To Next Amplifier

16 SXRC Remote Control