Fortinet 2 SXRC manual Autosearch function, Return to the Sxrc Setup menu

90 seec

AMP1AMP2

LOCK LEFT SYS RIGHT MUTE GAIN EQ LPF HPF PHASE KOMP

MEM-1MEM-2MEM-3MEM-4

a uttoosseeaarrch

AMP1AMP2

LOCK LEFT SYS RIGHT MUTE GAIN EQ LPF HPF PHASE KOMP

led time MENU - The backlit keys on the SXRC have two intensity modes, On and Dim. This menu lets you select how long the SXRC waits when there is no button press activity before switching from the On

autosearch MENU - You should be familiar with this menu from the software updates we did earlier in the manual. The AUTOSEARCH function

seeks out any amplifier connected to the

level to the Dim level. The default is 90 seconds.

MEM-1 MEM-2 MEM-3 MEM-4

SXRC Communications Network, updates

the amplifier’s software if required and loads it in to the SXRC.

Use the UP and DOWN arrow keys to
scroll through the available settings:
1 sec.(shortest delay) to 240 sec.	ESC HOME	ENT
(longest delay)

If for any reason you lose an amplifier from the SXRC due to being un-plugged from the Communications Network, bad cable, etc. OR if you are adding a new amplifier to the SXRC you use this function.

Press the ENT key to activate the

Operation

Press the ESC key to save the setting and
return to the DISPLAY menu.	ESC HOME	ENT

Autosearch function.

ESC HOME ENT

NOTE:

This menu item works hand-in-hand with the LED ON LVL and LED DIM LVL menu items. Use this menu setting to determine how long your ISIS keys stay brightly lit after making your SXRC adjustments.

At this point you have explored all the settings in the DISPLAY menu. Press the ESC key to

The SXRC will perform all of its steps (highly detailed on page

18...attempting to save a forest here...go back and check it out there.) and return to the SXRC SETUP menu.

return to the SXRC SETUP menu.

ESC HOME ENT

SXRC Remote Control 61