Fortinet 2 SXRC manual Oaaddiinng, Avve alll

MEM-4

M4

s avve alll

MEM-1MEM-2MEM-3

AMP1AMP2

LOCK LEFT SYS RIGHT MUTE GAIN EQ LPF HPF PHASE KOMP

SAVE ALL MENU - Here you can download the current SXRC settings for each amplifier into any one of the four SX Series amplifiers on-board memories. (Mem-1through Mem-4)

This is useful for several purposes.

1.) You could have a preferred setup programmed into the SXRC and then simply plug it into the system and download all the settings into the amplifiers. Then un-plug the SXRC and the settings are now loaded into one of the amplifier’s memory

Once you are in the SAVE ALL menu you need to decide if you want to download

the current settings in the SXRC or any one of the four SXRC global memories.

If you want to download the current settings in use, skip the steps marked with a *

* Press any one of the four SXRC global memory presets to load it into the SXRC.

M1 M2 M3

Operation

presets for use. Talk about a one-touch programming tool!

2.) You may want to disconnect your SXRC from the system and take it with you. By saving all the current settings in the SXRC to the amplifiers the system will operate without the SXRC

*The display will show LOADING while the global memory preset loads and then the display will show which preset is loaded and active.

AMP1 AMP2

LOCK LEFT SYS RIGHT MUTE GAIN EQ LPF HPF PHASE KOMP

l oaaddiinng

MEM-1 MEM-2MEM-3 MEM-4

but with the exact settings you were using.

3.) The 3-step-plan to sanity: Save, Save and Save. By saving your current settings from the SXRC into your amplifiers you have a backup of all your programming. If something should ever happen to your SXRC (Beverage spill, Sat on and crushed, girlfriend throws out the window at 60 MPH) you will have all your hard-earned system programming backed-up in your amplifiers. You could then follow the 3-step-plan to happiness: Remember, Remember, Remember. Simply plug in a new (or repaired) SXRC, perform an Autosearch, save the settings back into a global SXRC memory and your back in business.

Press the ENT key to enter the SAVE ALL memory location selection menu.

Use the UP or DOWN keys to scroll through the available memories (mem-1through mem-4). This will be the memory preset the SXRC uses on each amplifier to store your settings.

When you have the memory selected that you want to use simply press the ENT key to select it.

ESC HOME ENT

ESC HOME ENT

ESC HOME ENT

Ain’t technology just swell!

The settings will be saved to the SX Series amplifiers and the display will return to SAVE ALL. You are now back in the SXRC SETUP menu.

AMP1 AMP2

LOCK LEFT SYS RIGHT MUTE GAIN EQ LPF HPF PHASE KOMP

s avve alll

MEM-1 MEM-2 MEM-3 MEM-4

SXRC Remote Control 71