Sony NSX-A777 manual Press Clock, Press Enter or Il, To restore an original clock setting

The clock is displayed. (The “:”between the hours and minutes flashes.) When the power cord is plugged into an AC outlet for the first time after purchase or when the clock setting is canceled due to a power failure, the entire clock display flashes.

1 Press CLOCK.

When using the remote control, press CLOCK while pressing

SHIFT.

2 Within 4 seconds, turn MULTI JOG to designate the hour and the minute.

Turning MULTI JOG changes both the hour and the minute.

+< or - is also available instead of MULTI JOG. Holding these buttons down will vary the time rapidly.

3 Press ENTER or Il.

The clock starts from 00 seconds.

To restore an original clock setting

Press CLOCK before completing step 3 to restore the previous time setting. This cancels any new setting.

To view the clock when another display is in the display

Press CLOCK. The time is displayed for 4 seconds and then the

original display reappears. However, the clock cannot be

displayed during recording.

To switch to the 24-hour standard

Press the CLOCK and then press ■ within 4 seconds. Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes

This is caused by a power interruption. The current time needs to be reset.

If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.

If the power-economizing mode (page 7) is on, all the display lights turn off when the power is turned off. To view the clock, press CLOCK so that the time is displayed for 4 seconds.

The unit can be turned off automatically at a specified time.

Use the remote control.

7 Press SLEEP while pressing SHIFT.

2 Within 4 seconds, turn MULTI JOG to specify the time until the power is turned off.

The time changes between 5 and 240 minutes in 5-minute steps.

+and > are also available instead of MULTI JOG. Specified time

To check the time remaining until the power is turned off

Press SLEEP once while pressing SHIFT. The remaining time is

displayed for 4 seconds.

To cancel the sleep timer

Press SLEEP twice while pressing SHIFT so that “SLEEP oFF

appears on the display.

26 ENGLISH