Hitachi C47-WD8000, C57-WD8000 instruction manual Antenna, Program Number selected, Tv/Video, AV5

ON-SCREEN DISPLAY MENU SETUP MENU

10 If the picture is noisy due to weak RF signals from some channels, you can reduce noise by using TV NR

7XQLQJź 

7XQLQJ0RGH &&,5

function.

Press the Ÿź cursor buttons to select the TV NR option and then press the ŻŹ cursor buttons to select Off, Low and High to turn off noise reduction function, activate low noise reduction and high noise reduction respectively.

Different channels can be set independently.

Note: This option is valid only for RF signal from

3URJUDP1XPEHU

6HDUFK

6NLS

6RXQG6\VWHP

&RORU6\VWHP

3URJUDP1DPH

7915Ź

$OO3URJUDP



0+]

2II

$XWR

$XWR



2II

antenna.

6HOHFW 6HW 5HWXUQ

11 All Program in Tuning menu can automatically

7XQLQJź



search all available frequencies and store all stations



7XQLQJ0RGH

&&,5

available to the program numbers starting from the current

3URJUDP1XPEHU



program No.

6HDUFK

0+]

Press the Ÿ ź cursor buttons to select the Program

6NLS

2II

Number option on the menu, press the Ż Ź cursor

6RXQG6\VWHP

$XWR

buttons or number buttons to select program No.

&RORU6\VWHP

$XWR

Press the Ÿ ź cursor buttons to select the All Program

3URJUDP1DPH



option as shown on the right. Then press the

ENTER

7915

2II

button to begin the auto tune procedure. The word

$OO3URJUDP

Ź

Searching will appear at the bottom of the menu, and the

6HOHFW

6HW

5HWXUQ

TV will search for all frequencies and store all tuned

frequencies to the program numbers starting from the

Program Number selected.

In the process of searching, press the

button to quit.

ENTER

After complete the searching, the TV will quit the menu automatically.

AV PRESETTING

3UHVHWź



Press the

button to switch the picture to the

TV/VIDEO

$90RGH

$9

Ź

AV mode.

&RORU6\VWHP

$XWR

Enter the Preset menu to display the menu as shown on the

 6HOHFW

6HW

5HWXUQ

right. Press the Ÿ ź cursor buttons to select the AV



Mode option and the Ż Ź cursor buttons or the



TV/VIDEO

button to select AV1, AV2, AV3, AV4 or



AV5.

Press the Ÿ ź cursor buttons to select the Color System



option, then press Ż Ź cursor buttons to select Auto,



PAL, SECAM, NTSC4.43 or NTSC3.58.



If the picture in AV mode is abnormal resulted from

incorrect color system, you can use the Color System

option to select the correct system.

When receiving component signal (Y, PB/CB, PR/CR) from INPUT1 (or HDMI input) or INPUT2 terminal, though the Color System option can be set, it has no effect on the picture. This is normal.

26