Hitachi C47-WD8000, C57-WD8000 Addenda, Guide to simple problem solving, Accessories

ADDENDA

A guide to simple problem solving

Before calling up the service personnel, please check the following chart for a possible cause to the problem you are encountering.

Symptom	Possible causes
No picture,no sound,power/standby indicator is OFF.	The power cord is not plugged in.
No picture,no sound,power/standby indicator is ON.	The TV is in standby mode.
No sound	The volume control is set to minimum.
	The Speaker option in Setup menu is set to Off.
Twist image and poor sound	The antenna signal is too weak or too strong.
	The TV is not tuned correctly.
Poor brightness, color or tint	The contrast, brightness, color or tint may be misadjusted.
Snowy picture	Interference from motorcycles, high-tension line, electric hair drier,
	personal computer or radio station.
Ghosts	Check the direction, height or position of the antenna.
No color	The antenna signal is too weak.
	Color System or Sound System is not set properly.
Remote controller does not work.	The batteries in the remote controller may be exhausted.
	The batteries may be improperly installed.
	There is obstruction between the remote controller and the TV.

HITACHI Projection Television incorporates advanced power surge protection technology designed to protect against component or circuit damage due to external or internal power surges.

If your TV appears A LOSS OF POWER, please follow the following procedure:

1. Press the POWER button once.

2.If there is still no power, wait for 30 seconds and press the POWER button again.

3.If there is still no power, unplug the power cord from the wall outlet. Wait for 30 seconds and plug the power cord in. Press the POWER button again.

The protective technology should provide you years of lasting entertainment from your HITACHI Projection Television.

The following phenomena are not failures:

1The picture takes a while to appear on the screen when the power is on.

2The cabinet clicks. The clicking is a creaking sound produced when the cabinet expands or contracts due to changes in temperature.

3Unevenness in color sometimes develops in part of the screen. Such unevenness in color may occur depending upon the nature or setting of the picture. The proper color may be restored by reducing the contrast or adjusting other settings.

4The TV set can generate sound distortion in external devices such as a radio. Please place the radio equipment away from the TV set.

Accessories

No.	Description	Quantity	C47-WD8000	C57-WD8000
1	Instruction manual	1	Yes	Yes
2	Remote control unit (CLE-962)	1	Yes	Yes
3	Battery (For CLE-962)	2	Yes	Yes
4	IR BLASTER cable	2	Yes	Yes
5	Caster holder	4	Yes	Yes
6	Antenna adapter	1	Yes	Yes

66