Hitachi C47-WD8000, C57-WD8000 instruction manual 5HVHW  6HOHFW 6HW 5HWXUQ

MULTI PICTURE

P in P

Follow the steps on page 20 to enter the Function menu and select the Multi Picture option, then enter the Multi Picture menu and select the Multi Picture option as shown on the right. Press the ŻŹ cursor buttons to set the Multi Picture option to P in P mode, then exit from the menu.

In normal TV mode, press the MULTI PIC. button to enter the P in P mode as shown below. Picture A and B will show the programs of two channels respectively.

P in P mode will have different display formats according to the signal format received.

	0XOWL3LFWXUH ź	
	0XOWL3LFWXUH Ź		3LQ3
	&+6XUI		
	)UHH]H		6WLOO
	+36HOHFW		$%
	5HVHW
	 6HOHFW 6HW	5HWXUQ
		
		

1When both the main picture and sub picture are receiving from RF, video or component signals (525i or 625i) or HDMI signal (525i or 625i), the P in P mode will display as shown in figure 1.



A

B 

Figure 1.

Note: In this mode, press the SWAP button to exchange the program sources of picture A and B.

2When the main picture receives 1125i HD signal and the sub picture receives RF, video or component signals (525i or 625i) or HDMI signal (525i or 625i), the P in P mode will display as shown in figure 2.

A

$9

B 

Figure 2.

Note: In this mode, press the SWAP button, it will change from figure 2 condition to figure 1. However, picture B will not be displayed normally and the ! symbol will appear. This is normal.

34