Giantec tracer2000 manual Features

Page 10

tracer2000 Network DVR Hardware User’s Manual

Features

The tracer2000 comes with the following hardware devices:

ƒControl Panel with IR Receiver

ƒOne 10/100Mbps TX Fast Ethernet with RJ-45 Connector

ƒOne RS232 and one RS232/422/485 Selectable Interface

ƒOne VGA (DB-15) Connector

ƒOne Speaker Out

ƒOne Microphone In

ƒTwo USB Ports (USB 1.1 Interface)

ƒTwo 3.5” HDD Supported

ƒFour Audio-in Ports

ƒEight GPIO Ports

ƒSupport IR Controller to Remote Control tracer2000

ƒWorking Temperature: 0°C ~ 40°C

ƒStorage Temperature: -10°C ~ 65°C

ƒRelative Humidity: Maximum 85%, non-condensing

ƒPower Requirement: AC100 ~ 240V, 50 / 60Hz, 150W Maximum

ƒDimension: 265mm (D) x 321mm (W) x 103mm (H)

ƒWeight: 5.0kg

Version 3.1

Page 2 of 31

Image 10
Contents Tracer2000 Page Warranties Copyright NoticeTrademarks Page Email for technical support Giantec Internet ServicesWorld Wide Web WWW site for product information Page Table of Contents Chapter System HDD Installation Guide Function Introduction Limited WarrantyChapter Introduction Before proceeding, please read this manual thoroughlyFeatures Chapter Package Chapter Installation Cable Connection IndicatorConnect VGA Monitor Connect Camera Cable to BNC Connector Connect to Printer Port Option Power Connector Internal Jumpers and Connectors Chapter Pin AssignmentPower Connector P1 Signals Power Switch for ATX Power Supply JP1 SignalsReset / LED / Speaker JP1 Cmos Clear J1CPU FSB Select JP4 Function COM2 Mode Select JP3HDD Connector IDE1 Pin No FAN Control FAN1 FunctionParallel / Printer Connector PRN Pin No Video Input J2 Pin NoGeneral Purpose Input / Output J3 Pin No Signal Infra-Red IR Pin No SignalPCI Bus Pin Assignment Audio Input Connector Gpio Connector External ConnectorCRT Display Connector VGA Pin No Signal USB Connector USB PortsCOM1 Connector RS232 Connector COM1 Pin No Signal COM2 Connector RS232 / RS422 / RS485 Connector COM2 Pin NoConnectors Ethernet Connector RJ-45Drawing of Ethernet Connector RJ-45 Pin No Signal Component LabelJumper 3 Setting of COM2 P/T/Z SettingRS232 / RS422 / RS485 Connector COM2 Pin No Pin Assignment of COM2Setup Pages Chapter Cmos SettingIntroduction Standard Cmos Features EGA/VGAAdvanced Bios Features CD-ROMAdvanced Chipset Features Tracer2000 Network DVR Hardware User’s Manual Integrated Peripherals SPPPower Management Setup DpmsPnP / PCI Configuration PC Health StatusSave & Exit Setup Load Optimized DefaultsSupervisor / User Password Frequency / Voltage ControlChapter System HDD Installation Guide Remove the screws on the case. Marked in while circlesTake off the upper cover and remove the screws Remove HDD tray, and install HDD properly Tracer2000 Network DVR Hardware User’s Manual