Giantec tracer2000 manual P/T/Z Setting, Pin Assignment of COM2, Cable Connection

tracer2000 Network DVR Hardware User’s Manual

3.2P/T/Z Setting

The P/T/Z Setting complies with LILIN or PELCO. Protocol has been previously attached to the COM ports. You may control the camera via arrow buttons. In this case, you don’t need to buy dedicated P/T/Z controller.

3.3Pin Assignment of COM2

Connect 9 PIN Female D_SUB to COM2 (Pin defines as below).

1 5

6 9

RS232 / RS422 / RS485 Connector (COM2)

Pin No.	RS232	RS422	RS485
1	DCD	TX-	DATA-
2	RX	TX+	DATA+
3	TX	RX+
4	DTR	RX-
5	GND	GND	GND
6	DSR	RTS-
7	RTS	RTS+
8	CTS	CTS+
9	RI	CTS-

Note: Please setup mode type by JP3.

3.4Cable Connection

Camera input jack to COM2 for PIH-7000/7600. For example:

3.5Jumper 3 Setting of COM2

The system default of COM2 is RS485. Adjust jumper JP3 in system for RS422, RS232 signals as show below.

JP3

1 2

17 18

RS485

JP3 JP3

1 2 1 2

17 18 17 18

RS422 RS232

Version 3.1 Page 18 of 31