Giantec tracer2000 manual Tracer2000 Network DVR Hardware User’s Manual

Page 39

tracer2000 Network DVR Hardware User’s Manual

4.Insert the assembled HDD tray into tracer2000, and connect both power and HDD.

5.Assemble the upper cover and the screws.

Version 3.1

Page 31 of 31

Image 39

Contents Tracer2000 Page Copyright Notice WarrantiesTrademarks Page Giantec Internet Services Email for technical supportWorld Wide Web WWW site for product information Page Table of Contents Chapter System HDD Installation Guide Before proceeding, please read this manual thoroughly Limited WarrantyChapter Introduction Function IntroductionFeatures Chapter Package Chapter Installation Indicator Cable ConnectionConnect VGA Monitor Connect Camera Cable to BNC Connector Connect to Printer Port Option Power Connector Chapter Pin Assignment Internal Jumpers and ConnectorsCmos Clear J1 Power Switch for ATX Power Supply JP1 SignalsReset / LED / Speaker JP1 Power Connector P1 SignalsFAN Control FAN1 Function COM2 Mode Select JP3HDD Connector IDE1 Pin No CPU FSB Select JP4 FunctionVideo Input J2 Pin No Parallel / Printer Connector PRN Pin NoInfra-Red IR Pin No Signal General Purpose Input / Output J3 Pin No SignalPCI Bus Pin Assignment USB Connector USB Ports External ConnectorCRT Display Connector VGA Pin No Signal Audio Input Connector Gpio ConnectorCOM2 Connector RS232 / RS422 / RS485 Connector COM2 Pin No COM1 Connector RS232 Connector COM1 Pin No SignalComponent Label Ethernet Connector RJ-45Drawing of Ethernet Connector RJ-45 Pin No Signal ConnectorsPin Assignment of COM2 P/T/Z SettingRS232 / RS422 / RS485 Connector COM2 Pin No Jumper 3 Setting of COM2Chapter Cmos Setting Setup PagesIntroduction EGA/VGA Standard Cmos FeaturesCD-ROM Advanced Bios FeaturesAdvanced Chipset Features Tracer2000 Network DVR Hardware User’s Manual SPP Integrated PeripheralsDpms Power Management SetupPC Health Status PnP / PCI ConfigurationFrequency / Voltage Control Load Optimized DefaultsSupervisor / User Password Save & Exit SetupRemove the screws on the case. Marked in while circles Chapter System HDD Installation GuideTake off the upper cover and remove the screws Remove HDD tray, and install HDD properly Tracer2000 Network DVR Hardware User’s Manual