Giantec tracer2000 manual Chapter System HDD Installation Guide

Page 36

tracer2000 Network DVR Hardware User’s Manual

.

Chapter VI

System HDD Installation Guide

Follow the step to setup HDD drawing box.

1.Remove the screws on the case. (Marked in while circles)

Remove the screws on the case.

Version 3.1

Page 28 of 31

Image 36

Contents Tracer2000 Page Copyright Notice WarrantiesTrademarks Page Giantec Internet Services Email for technical supportWorld Wide Web WWW site for product information Page Table of Contents Chapter System HDD Installation Guide Limited Warranty Chapter IntroductionFunction Introduction Before proceeding, please read this manual thoroughlyFeatures Chapter Package Chapter Installation Indicator Cable ConnectionConnect VGA Monitor Connect Camera Cable to BNC Connector Connect to Printer Port Option Power Connector Internal Jumpers and Connectors Chapter Pin AssignmentPower Switch for ATX Power Supply JP1 Signals Reset / LED / Speaker JP1Power Connector P1 Signals Cmos Clear J1COM2 Mode Select JP3 HDD Connector IDE1 Pin NoCPU FSB Select JP4 Function FAN Control FAN1 FunctionParallel / Printer Connector PRN Pin No Video Input J2 Pin NoGeneral Purpose Input / Output J3 Pin No Signal Infra-Red IR Pin No SignalPCI Bus Pin Assignment External Connector CRT Display Connector VGA Pin No SignalAudio Input Connector Gpio Connector USB Connector USB PortsCOM1 Connector RS232 Connector COM1 Pin No Signal COM2 Connector RS232 / RS422 / RS485 Connector COM2 Pin NoEthernet Connector RJ-45 Drawing of Ethernet Connector RJ-45 Pin No SignalConnectors Component LabelP/T/Z Setting RS232 / RS422 / RS485 Connector COM2 Pin NoJumper 3 Setting of COM2 Pin Assignment of COM2Chapter Cmos Setting Setup PagesIntroduction Standard Cmos Features EGA/VGAAdvanced Bios Features CD-ROMAdvanced Chipset Features Tracer2000 Network DVR Hardware User’s Manual Integrated Peripherals SPPPower Management Setup DpmsPnP / PCI Configuration PC Health StatusLoad Optimized Defaults Supervisor / User PasswordSave & Exit Setup Frequency / Voltage ControlChapter System HDD Installation Guide Remove the screws on the case. Marked in while circlesTake off the upper cover and remove the screws Remove HDD tray, and install HDD properly Tracer2000 Network DVR Hardware User’s Manual