Giantec tracer2000 manual Indicator, Cable Connection, Connect VGA Monitor

Page 13

tracer2000 Network DVR Hardware User’s Manual

1.Indicator

Power LED: The green light shows power is on.

H.D.D. LED: The green light flash is HDD working.

H.D.D

LED

2.Cable Connection

Following is the basic device must be prepared before to start installation complete system.

1.tracer2000

2.CCD Cameras

3.VGA Monitor

Please follow the procedure to connect the cable.

2.1Connect VGA Monitor

Version 3.1

Page 5 of 31

Image 13
Contents Tracer2000 Page Warranties Copyright NoticeTrademarks Page Email for technical support Giantec Internet ServicesWorld Wide Web WWW site for product information Page Table of Contents Chapter System HDD Installation Guide Chapter Introduction Limited WarrantyFunction Introduction Before proceeding, please read this manual thoroughlyFeatures Chapter Package Chapter Installation Cable Connection IndicatorConnect VGA Monitor Connect Camera Cable to BNC Connector Connect to Printer Port Option Power Connector Chapter Pin Assignment Internal Jumpers and ConnectorsReset / LED / Speaker JP1 Power Switch for ATX Power Supply JP1 SignalsPower Connector P1 Signals Cmos Clear J1HDD Connector IDE1 Pin No COM2 Mode Select JP3CPU FSB Select JP4 Function FAN Control FAN1 FunctionVideo Input J2 Pin No Parallel / Printer Connector PRN Pin NoInfra-Red IR Pin No Signal General Purpose Input / Output J3 Pin No SignalPCI Bus Pin Assignment CRT Display Connector VGA Pin No Signal External ConnectorAudio Input Connector Gpio Connector USB Connector USB PortsCOM2 Connector RS232 / RS422 / RS485 Connector COM2 Pin No COM1 Connector RS232 Connector COM1 Pin No SignalDrawing of Ethernet Connector RJ-45 Pin No Signal Ethernet Connector RJ-45Connectors Component LabelRS232 / RS422 / RS485 Connector COM2 Pin No P/T/Z SettingJumper 3 Setting of COM2 Pin Assignment of COM2Setup Pages Chapter Cmos SettingIntroduction EGA/VGA Standard Cmos FeaturesCD-ROM Advanced Bios FeaturesAdvanced Chipset Features Tracer2000 Network DVR Hardware User’s Manual SPP Integrated PeripheralsDpms Power Management SetupPC Health Status PnP / PCI ConfigurationSupervisor / User Password Load Optimized DefaultsSave & Exit Setup Frequency / Voltage ControlRemove the screws on the case. Marked in while circles Chapter System HDD Installation GuideTake off the upper cover and remove the screws Remove HDD tray, and install HDD properly Tracer2000 Network DVR Hardware User’s Manual