Image, Alarm | Mace DVR0404RW, DVR1604RW, DVR0804RW guide

Pan-tilt control

Image	In	CH	option select the related channel. In MODE there are CBR

(audio/video) and VBR (audio/video). AV is audio and video synchronization, Video is the mode without audio (when there is no audio input

use this way to save HDD space).When in CBR, Framerate is Real time, Bitrate is the related maximum data flux. Use direction key to select the different bitrates. When in VBR, Framerate 1f/s-25f/s are selectable. Video Loss on means that alarm will be on when the video is lost, and also trigger the relay device.

Alarm		Select the relevant Camera in				CH	(this recorder has 8-Ch alarm input).

		TYPE		has NO (normal open) NC (normal close) output modes. If the

	Camera number in RECORD is selected, recording would be started for that
	Camera automatically when there is alarm input. If the alarm output port is
	chosen, it will trigger the corresponding relay when there is an alarm input.
			means to extend the recording time after receiving alarm signal
	DELAY
	clears.10, 20, 30 90SEC delays. When the outside alarm is cleared, the
	system will extend the recording time automatically before closing alarm and
	relay output. When Time 1 or Time 2 are on, if an alarm occurs within the time
	of these settings, the recording will be triggered by alarm signals. The beginning
	time should be earlier than the ending time. The setting in Time 2 should be
	later than the setting in Time 1.							is used to transmit the alarm signals
					ALMSVR IP
	to the designated IP server.

Select the corresponding channel in CH, and choose the protocol of the brand name of the corresponding pan-tilt decoder in

PROTOCOL. ADDR is the address of the corresponding PTZ Camera.



CH	1
MODE		CBR AV
FRAMERATE			REAL
BITRATE			1024K
VIDEO LOSS			OFF
COVERED			OFF
VIDEO	SET DEFAULT
TITLE	01		ON
CYCLE			OFF
	SAVE		CANCEL