Mace DVR0804RW, DVR1604RW, DVR0404RW manual Network, Motion detection

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿ ￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

Network	IP is set by using ￿￿ or input the exact numbers to change
	the IP address. IP address setting can only be here. The related
SUBNETMASK and GATEWAY should be set according to the IP
address. MONITOR and PLAYBACK can be changed by using
￿￿TCP/IP or MULTICAST. Save the setting in SAVE, and restart the

recorder.

Note:

MULTICAST: The users with Admin levels can monitor each channel freely. All other users can only view after Admin releases camera. 5 users at maximum.

TCP Protocol: All users are able to monitor any channel. User shall select Camera # desired. If the transmission is over Internet, TCP should be chosen. 2 users can log in at a maximum.

Motion detection	Select the Camera channel in			CH	. Open or close (On/Off)
	the function in		. Choose how long you want to
		STATE

continue the recording (10, 20, 30, ……90SEC) when motion is detected

and then cleared. ALMOUT controls the alarming state for motion detection. SENS has three levels: LOW, MID, HIGH. AREA can be

accessed by pressing ENTER. The setting area can be divided in 192 sections. Red section means the current cursor position, and the blue section is the motion detection area. Areas with no color are no motion detection areas. Press Fn to locate the current section, then move the cursor to cover the MD area needed; press Fn again to choose the MD area. Press ￿￿ to get the setting and press ENTER to confirm.

CH	1
DELAY	30 SEC
ALMOUT	OFF
SENS	MID
AREA	SET
SLOT1	08:00AM – 08-00PM ON
SLOT2	08:00AM – 08-00PM OFF

SAVE CAMCE;

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿ 35 ￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿!￿