Maxtor AVE MVDR-5000 operation manual Hard Disk Installation, Built-in hard disk

Page 61

6.2 Hard Disk Installation

4.5.

Usually, the unit comes with one hard-disk drive installed in compartment HD 1, which is default-configured as a master. The jumper settings configuration of the installed hard-disk drives for the unit and compatible drives which can be used with this unit are listed in the table below. To install two hard disk drives in the compartments for HD 1 and HD 2, please take the following steps.

The jumper settings of hard-disk drives for the system

Setting the jumper of your hard disk driver. The way to set the jumper of the drive varies between manufacturers; please refer to the instructions on the driver to set the jumpers in the master position.

Place the hard disk in the rack.

	Location	Jumper
IDE 1	Compartment HD 1	Master
IDE 2	Compartment HD 2	Master

6.2.1 Built-in hard disk

1.

Unscrew all the 4 mounting screws on the mobile rack of the unit and detach it.

2.3.

Carefully lift the mobile	Unscrew the secured
rack to a vertical	screws to detach the
position.	hard disk rack.

6.

Secure the driver in the rack using 4 mounting screws in the side-mounting holes. Please don’t tighten the screws too much, otherwise that may damage the driver.

7.8.

Screw the rack into the Attach the interface device, screwing in all connector and the power

the 4 screws. connector to the drive. Please note the red lining of the IDE cable and the red wire of power cable must line up side by side.

59

Image 61

Contents Installation Page Safety Precautions Contents Introduction Product FeaturesProduct Introduction Front View Front / Rear ViewDisk Indicator Rec IndicatorUp / Down CH4 / CH3 buttons Enter / Quad buttonMobile Rack Power LED Power IndicatorShuttle Ring Jog DialRear View Alarm OUT, Disk FULL, RecordAbove figure is the rear view Alarm In / OutConnecting with 1 to 4 Cameras InstallationBasic Connection Attaching AN External Device to DVRLocation Jumper Hard-disk Drive InstallationWestern Digital MaxtorSamsung 01- 01-2005 System Information and Channel Selection+2 59G 12.4 HR 20 F/SUpdating System Software Mode Key Result Display Live Quad Record CH1CH2 CH3 CH4Operations Configuring Recording SettingsNtsc Audio OFF Ntsc Audio on 11KHzPAL Audio OFF OperationsPAL Audio on 11KHz Refresh Rate Frame/SecRecording Operations Timer RecordingManual Recording Main MenuMotion Alarm / Motion RecordingSet ALM Operation to ON/ OFF Externally Triggered Recording Normal Playback Playback OperationsFast Forward/Backward Slow Forward/ReversePlay back Picture-by-picture Picture in Picture PinP Display ModeSearch Operations Alarm List SearchFull List Search Time SearchThumbnail Thumbnail SearchClicking the Play button CD Menu SD Card SearchCD Menu for CD-ROM Model only Rack HD Backup Operations for more Backup Menu for HARD-DISK Model onlyCD Rewritable unit Backup Operations for CD-ROM Model only Backup OperationsSave Then set HD 2 Usage to Backup Set HD 2 to Backup first. Take the following stepsArchive Single image Clips into an SD Card SD Card Backup Operations for Removable HDD ModelArchive video of AVI clips into an SD card Save to F0000.JPG Save to F0001.JPG Save to F000N.JPGSave to M0000.AVI Save to M0001.AVI Save to M000N.AVI Key Lock Operation Backup the System setting info into an SD cardUpdating System Software SystemREC Setting Menu SetupREC Setting KEY FunctionsREC Quality Alarm / Motion SettingDisk Full Audio30F/S 30 fields per second, 15F/S, 10F/S PRE- AlarmALM Type ALM DurationMotion Setting Timer / SEQ / Title SettingSENSITIVITY1 ~ ClockREC Enable Communication SettingTimer SequencerFTP Setting NET EnableComm ID BaudDisk Setting System Setting Operation LOG OSD LanguageMenu Backgnd BuzzerDefault Setup PWDSD Setup VersionNetwork Network ConfigurationCable Connections Network Configure Your DVR Network SettingsPIN no Gateway MaskHttp Port Properties to enter the Local Area 3 TCP/IP Communication SetupConnection Network.Connections Local Area Connection Control PanelSelect Internet Protocol TCP/IP Click Start Command Programs Connection TestingTriplex 4 CH DVR Viewer Software Introduction Software installationShort introduction Message C\Program Files\ Viewer【Multiscreen Buttons】：You can Operation Remote ControlScroll the Original Image Size from ※ Capture / Print Print Click the Print Preview buttonRemind the condition of recording Remote play and PTZ controlRemote play Change Pan/Tilt/Zoom Setting【Backup to JPG】：【Backup up to AVI】：【Edit AVI】： Web Page Viewer Channel Number To chooseMicrosoft Internet Explorer Connecting the DVRBrowsing images from the DVR Change Record / Alarm SettingChange Timer Record Setting 1 RS232 & RS485 Setup RS-232 & RS-485 Setup & ProtocolGeneral Command Format MiscellaneousDEC HEX Non REC Mode REC ModeRequest State Second Category=0x06 Description of System StateBuilt-in hard disk Hard Disk InstallationMobile Rack for Removable HDD Model Page Enter System DefaultD Message Meanings O.S.D MessageHD1 Time Index Table12-02-03 01-30-04 3000 Indexes 2999 02-03-04 02-08-04 Point stops recording Previously recorded data remainingModel Number MVDR5000 SpecificationsScanIP Page For CD-RW Model only Appendix 1. Using CD DiscsInserting Disc Ejecting The DiscRMN040200310V3.3