Philips DV900VHS0I owner manual TurningonYourDVD/VCR, Helpful Hints

16 TurningonYourDVD/VCR

Before turning on your DVD/VCR, make sure batteries are in the remote control and the DVD/VCR and TV are connected correctly.

•You can not program channels if you are using a Cable Box or a Direct Broadcast System.

.

Press the VCR button, then press the POWER button.

"HELLO" will appear briefly on the front of the DVD/VCR.TheVCR

light, theVCR/TV _ight,and the POWER light will appear on the front of the DVD/VCR.

2

Turn on the TV. Set it to the same channel as the CH3/CH4

switch on the back of the DVD/VCR. The displayshown below will appear. (If the display does not appear, check your hookups, then follow the steps on page 17 to set up channelsand page 22 to select a language.)

-_ENGLISH	ON
_SPANOL

MAKE SELECTION OR

USH MENU TO CONTINUE

3

Within 60 seconds, press the PLAY button or the STOP but-

ton to select English or Spanish on-screen displays and menus.

4

Press the MENU button.

TO VCP,

THEN.

PUSH CH UP KEY

OR.

_CCONNECT ANTENNA OR CABLE 1 FOP, pLAy ONLY - PUSH STOP

5

Within 60 seconds, press the CHANNEL A button to begin automatic channel programming. AUTO CH PROGRAMMING IN PROCESS PLEASEWAIT will appear on the'IV screen.The DVD/VCR will memorize all availablechannels.When all channels are

memorized, CHANNELS ARE SET will appear on the screen briefly, then TV programming will appear.

These channels will be availablewhen you want to watch TV while in

VCR mode.To put the DVD/VCR in VCR mode, press the DVD/VCR OUTPUT button so that theVCR light appears.Then press the

VCR/TV button so that theVCR/TV light appears. Press theVCR but- ton, then use the CHANNEL and Number buttons to select aTV

channel for viewing.

2 Turn on the T_.

I

_

C3

ocuoU

SPEED

OCDOocuo

C300

_ __E_S TITLE -- 4

Helpful Hints

Toskip this feature and play a tape immediately, insert a tape with its record tab removed.Or, to skip step 3, press the MENU button.All on- screen displays will be in English.To skip step 5, press the STOPbutton. Channels will not be programmed, and CHANNELS NOT SETwill appear on the screen.

If you try to program channels when there is no antenna or cable con- nected to the DVD/VCR. program- ming will appear to take place,but eventually a NO TV SIGNALSmes-

sage will appear. Connect an anten- na or cable to the DVD/VCR'sANT-

IN (Antenna In) jack and press the CHANNEL A button again. If chan- nel programming does not resume, you may need to follow the steps on page 17.

You may need to repeat the steps on this page if a power failure

OCcurs.