Philips DV900VHS0I owner manual HelpfulHintscontd

Page 78

78 HelpfulHints(cont'd)

too

ooo,o

too,

.too

,too

ooQo • otto

too,

• trot

ooeooo

• to°,,

ttQo

• toot

• • ot,o

• • ootoooo,

ttttoo

• toot

• ol°t,oo

• • oo°o

•, • ootooooo

Power Failure

•Timer recordings, the clock setting, the languageselection, and channel setup may be lost if the power

fails for more than one minute. Follow the steps on pages 16and 20.Then, see pages36-38 to repro- gram your timer recordings.

A TV program cannot be recorded.

•Put the DVD/VCR inVCR mode. Pressthe DVD/VCR OUTPUT button so that the greenVCR light appears on the front of the DVD/VCR.

•Check the connections between the DVD/VCR,TV, antenna/cable,and Cable Box/Direct Broadcast System (if applicable).Details are on pages8-1 I.

•Make sure the tape has a record tab. Details are on page seven.

•Check theTV/VCR position. Detailsare on page 25.

•Check the CH3/CH4 switch. Detailsare on pages8-1 I. Or, if you connected the DVD/VCR to theTV

using audio and video cables,select the correct audio and video in channel at the TV. Detailsare on page 12.

The DVD/VCR will not perform a timer recording.

•Make sure the recording start and stop times are set correctly. Detailsare on pages36-39.

•Make sure a tape is in the DVD/VCR and the tape has a record tab. Detailsare on page seven.If,after pro- gramming a timer recording, you press the TIMER SETbutton without putting a tape in the DVD/VCR, theTIMER SET light will blink.

•_ the record tab on a tape is missing,the DVD/VCR will eject the tape.The TIMER SET light will blink.

•PresstheTIMER SET button to put the DVD/VCR in standby mode for the timer recording.TheTIMER SET light should appear on the front of the DVD/VCR.

•Make sure the clock is set. Details are on page 20.

•The DVD/VCR may not perform or continue a timer recording if a power failure of more than one minute occurs.

•If you have a Cable Box/Direct Broadcast System,timer recordings are programmed differently. Details are on page 10.

•Finish programming a timer recording at least five minutes before the recording is set to begin.

•12 p.m. is noon; 12a.m. is midnight.

There is no picture or the picture is noisy or contains streaks during video cassette tape play- back.

•Put the DVD/VCR inVCR mode. Pressthe DVD/VCR OUTPUT button so that the greenVCR light appears on the front of the DVD/VCR.

•Make sure the TV is on the same channel as the DVD/VCR'sCH3/CH4 switch. Or, if you connected the DVD/VCR to the TV using audio and video cables,select the correct audio and video in channel at the TV. Detailsare on page 12.

•Make sure the DVD/VCR is inVCR position. PresstheVCR/TV button so that theVCR/TV light appears on the front of the DVD/VCR.

•Make sure channel 03 or 04 is properly adjusted at theT_

•Adjust the tracking. Details are on page 45.

•TVs placed too close to the DVD/VCR can causeinterference during tape playback.Move the DVD/VCR away from the TV.

The Number buttons won't work for channels above 69.

•Enter channel numbers as a two-digit number. If you want to select channels 100and above,enter chan- nel numbers as a three-digit number. Details are on page 30.

TV programs cannot be watched normally.

•Put the DVD/VCR inVCR mode, then put it inTV position. Pressthe DVD/VCR OUTPUT button so that the greenVCR light appears.Then,press the VCR/TV button so that the VCR/TV light disappearsfrom the front of the DVD/VCR. Details are on page 29.)

•Check the connections between the DVD/VCR,TV, antenna/cable,and Cable Box/Direct Broadcast System (if applicable). Details are on pages8-1 I.

Page 77 Page 79
Image 78
Page 77 Page 79
Contents Card within I 0 days. See Verification For Customer UseHigh Quality Special Information for Canadian UsersRadio/TV Interference Declaration of ConformityTableof Contents Introduction5 WelcomeDisc Menus Color Systems PlayableDiscsRegion Codes Unacceptable DiscsRecording Prevention PlayableVideoCassetteTapes7Playable Video Cassette Tapes To allow recording, cover the hole with cellophane tapeBasic antenna/cable to DVD/VCR toTV is shown below HookupsWithouta CableBox/DirectBroadcastSystemDisconnect the antenna or cable from yourTV 300ohmHookupsWithouta CableBox/DirectBroadcastSystemcontd9 Plug in theTV and the DVD/VCRI0 HookupsWitha CableBox/DirectBroadcastSystem ConnectionsRecording/Viewing Any Channel Recording One ChannellWatching Another HookupsWitha CableBox/DirectBroadcastSystemcontdIIConnections Press the VCR/TV button once to put the DVD/VCR in TVConnecting the DVD/VCR to a Stereo TV OptionalHookupsDVD/VCR,no Disc will appear on the displaypanel OptionalHookupscontd13 Back of StereoExample only BackofTV OptionalHookupscontdRemoteControlSetup15 Recycling Guidelines/Battery SafetyPress the VCR button, then press the Power button TurningonYourDVD/VCRHelpful Hints Wait for a few minutes while the DVD/VCR sets up Press theVCR button, then press the Menu buttonPress the Play button or the Stop button to select Auto Helpful HnPress the DISPLAYISTATUS/EXIT button Adding/Deleting ChannelsPress the Play button or the Stop button to select Press the VCR button, then press the Menu buttonPress the DISPLAY/STATUS/EXIT button once or twice AutomaticChannelSetupcontd19Reviewing Memorized Channels To exitSettingtheClock Press two Number buttons for the month, two NumberDaylight.SavingsTime21 That OFF or on appears beside Daylight SVG TimePress the DISPLAY/STATUSIEXIT button LanguageSelectionVCR Helpful HintOn-ScreenStatusDisplaysVCR23 Press the Menu button24 DVD/VCRDisplay- DVDFeatures Disc loading tray Power LightIs on VCR Light Green DVD/VCRDisplayVCRFeatures25CST. in Cassette- Inside Light This light appearswhen a Is inVCR mode.You can only watchFrontPanel Play ButtonSTOP/EJECT Button Video OUT Jack RearPanel27Coaxial Jack ANT-OUT Antenna Out JackREWind Button DVD mode RemoteControlButtonsTitle Button RemoteControlButtonscantd29 Subtitle ButtonPause Button DVD mode RemoteControlButtonscantdSlow Button RemoteControlButtonscontd31 Audio ButtonPlayingVideoCassetteTape Insert a tape in the cassette compartmentRecordingonaVideoCassetteTape33 Insert a tape with its record tab intact into the cassetteTo stop recording, press the Stop button RecordingOneChannel/WatchingAnother Press the Stop button to stop the recordingOne-TouchRecording35 TimerRecording Daily RecordingUse the Number buttons I-8 to select a slot in which to Follow the instructions in to enter the recordingsPress TimerRecordingcontdNumber 2 button to record in SLP speed. See the chart Button to record in SP speed orTimerRecordingcontd39 Ee pae 78 for more hintsRerecordingTapeDuplication Make the connections shown abovePress the Speed button to select SP or SLP at DVD/VCR RepeatPlayVideoCassetteTapes41 Press the F.FWD button so that on appears besideReal-TimeCounterMemory While the status display is on the screen, pressWhile the real-timecounter is on the screen, press TimeSearch43 Within 10 seconds, press the F.FWD button orSpecialEffectsPlayback Forward and Reverse Searching SP/LP/SLPViewing a Slow Motion Picture Automatic Rewind, Eject Automatic Tracking AdjustmentAutomatic Playback Manual TrackingWhen MTSMulti.ChannelTelevisionSoundSystemUnderstanding On-ScreenDisplays Monaural SoundPress the VCR button, then press the Menu button Pres the Play button or the Stop button to selectHi-FiStereoSoundSystem Please see additional notesCb O Press the Play button or the Stop button to selectVCRPress the Displayistatusiexit button Playing a DVD or an Audio CD Before you begin Press the Power button to turn on the DVD/VCR.HELLOPlaying Disc Press the Stop button to stop playback. If disc playback isDiscMenus51 Using the DVD MenusUsing theTitle Menu Press the DVD button, then press the Menu button.PausingPlayback Press the Play button to resume playbackStepbyStepPlayback53 SlowMotionHelful Hints FastForward/ReverseSearch Occ UStarting Playback at a Specific Track Will beginplayingautomaticallyTitle/ChapterPlayback Starting Playback at a Specific Title/ChapterPress the DVD button, then press the Search Mode SpecificTimePlayback57Starting Playback at a Specific Disc Time RepeatPlaybackDiscs SelectPlay the Disc to the point at which you want repeated BRepeatPlayback59Press the A-B Repeat button to set the starting point a Playback BeginProgrammedPlayback @ UWhile playback is stopped, press the DVD button, then RandomPlayback61 While the Random screen appears, press the Play butAudioLanguage/SoundMode LanguageDVD MenuCameraAngles Accessing the Status Display DisplaysParentalLockLevels Press the Number buttons to enter the 4-digit password Press the Number 2 button to select Change PassAudioSettings To change the Digital OUT settings, go to stepPress the Number 3 button to select Audio Press the Setup button to remove the menu Audio signals are converted toGo to to change the settings within AUDIO, SUB LanguageSettingsPress the Setup button, The setup screen appears Press the Number I button to select LanguagePress a Number button to select a setting LanguageSettingscontd TajikTamil Press the Number 2 button to selectVIDEO VideoSettings73Press the corresponding Number button to select a set- ting LE,,0,.kEPress the Number 5 button to select Others OtherMenuSettingsWhen disc playback is stopped, press the DVD button Press the corresponding Number button to select an itemCleaning a Disc CareandMaintenance75Cleaning the DVD/VCR Checling the LaserDVD/VCR has no power Remote control will not operate the DVD/VCRNo picture in DVD mode HelpfulHintsAudio or subtitle language cannot be changed DVD/VCR switches to VCR mode automaticallyDistorted picture Camera angle cannot be changedHelpfulHintscontd Tape cannot be inserted Line Input modeCleaning the Video Heads Tape cannot be removedGlossary From a distanceSpecifications81 LimitedWarranty WHO is COVERED?Index83 Are provided to help you use or set up your DVD/VCR RO. Box
Top Page Image Contents