Taking a First Look
■
User Manual |
54 |
Tips and Troubleshooting
You can quickly solve most problems that you encounter with the RC9800i by following the advice in this chapter.
RC9800i device
My RC9800i switches off automatically
If your RC9800i is not being used, it will switch to standby mode. To wake the RC9800i, see ‘Everyday Use’ on page 6.
You can set the amount of time the RC9800i waits before going into sleep mode. For further information, see Power Settings on page 42.
My RC9800i doesn’t respond
When the battery is running empty, your RC9800i may not respond anymore. You should then recharge it, see ‘Charging the RC9800i’ on page 8.
If after recharging your device still does not respond, you may have to reset it. Under normal circumstances you’ll never have to reset the RC9800i. However on rare occasions, if the touch screen freezes or if you notice unusual behavior, you may need to perform a reset. Switch the On/Off Switch off and, after a few seconds, on again. The Homepage will appear. The On/Off Switch is located at the backside of the RC9800i, see page 6.
The soft buttons on my touch screen do not respond properly
If after some time the touch screen doesn’t respond correctly to the area that you are touching, you should recalibrate the screen. To calibrate the touch screen, take the following steps:
1On the homepage, choose 
.
The System Management Area will appear.
2Choose Settings.
The ‘Settings’ screen will appear.
3Choose RC9800i settings.
The ‘RC9800i Settings’ screen will appear.
4Choose Screen.
5Choose Calibrate screen.
6Very precisely tap the crosshairs that appear in the four corners of the screen. The RC9800i may repeat this process a number of times until its screen is accurately calibrated.
How do I clear all settings on my RC9800i?
Reverting to the original configuration or factory settings restores the settings that were on your RC9800i when you purchased it. To revert to Factory Settings, take the following steps:
Attention! Reverting to factory settings will delete all rooms and devices information that you provided during the earlier setups.
1On the Homepage choose 
.
The ‘System Management Area’ screen will appear.
2Choose Settings.
The ‘Settings’ screen will appear.
3Choose Erase All.
A screen asking for confirmation will appear. If you are sure you want to erase all settings, choose OK. Otherwise choose Cancel.
4The RC9800i will restart and launch the initial setup wizard.