Philips HDRW 720/00-02 operating instructions Programming recordings without the ShowView System

Programming a recording (TIMER)

a'Please enter programme number' appears on the screen

bThis message appears when the TV channel has not been assigned in the GUIDE Plus+® system yet.

To change channel data, proceed as follows:

-Press A .

-Select 'Editor' with C .

-Select the TV channel using B or A .

-Press C to go to the right tile.

In case you can receive the selected channel only via an external receiver, press the red button to select the corresponding source.

-Press the green button.

-Enter the programme number of the TV channel using the number buttons.

If the source you have selected is an external receiver, enter the programme number that you would also enter at the external receiver for this TV channel.

-Confirm with OK .

aThe following message appears on the screen: 'ShowView number wrong'

bThe entered ShowView number is incorrect. Repeat the entry or end with TIMER s .

b Check time/date (see chapter 'Installing your DVD recorder', section 'Setting the time & date').

ShowView Manual Home

Please enter the ShowView programming number and press OK to confirm.

1 2 3 4 5 = = = =

Grid		Search		Schedule	Info
/Record					Freq. Timing
21-Oct	20:00 21:30		BBC1		Once 0

6The decoded data appears after confirmation.

You can use the colour buttons to make the following settings. First, the right tile must be highlighted ( C button). Check the functions (descriptions) in the corresponding colour field before pressing a button.

Activate 'VPS/PDC'

Keep pressing the yellow action button until 'VPS/PDC' appears instead of the time.

Setting up repeat recordings

You can choose from the following settings with the green action button:

'Frequency': 'Once': single recordings

'M-F': Repeated daily recordings (Monday to Friday).

'Mon': Repeated weekly recordings (every week on the same day e.g. Monday).

7If all information is correct, press the OK button. The data is stored.

8To end, press TIMER s .

If one or more recordings have been programmed 'TIMER' will light up on the display.

Programming recordings without the ShowView® System

Preparation:

•) The TV set is switched on, and, if necessary, the programme number for the DVD recorder has been selected.

•) the DVD recorder is switched on.

1Press TIMER s on the remote control.
	P The 'Schedule' screen appears						ENGLISH
	a	I will see some informations about the GUIDE Plus+®
		System
	b The GUIDE Plus+® System was not installed yet. Read therefore in
		the chapter 'The GUIDE Plus+® System' the section 'Set up the
		GUIDE Plus+® System'.
			ShowView	Manual		Home
			Schedule displays programmes for Record. Press
			Bto use. Press the Red button for ShowView
			recording. Press the Green button for Manual
			recording. Press Dfor Search. Press Cfor Info.
			Grid	Search	Schedule	Info

No programmes

2Press the green button.

P The current date will be displayed.

3Enter the date using the number buttons 0..9

4Confirm with OK .

How can I correct wrong entries?

If you have already confirmed the entry with OK , you can select one of the following functions:

Repeat entry: Green colour button

Cancel: Red colour button

5Enter the start time for the show using the number buttons 0..9 . Confirm with OK .

6Enter the finish time for the TV show using the number buttons 0..9 Confirm with OK .

7Check the data you entered.

O If necessary, go back a position to change entered data using the green function button.

45