Philips CCC134, CCC194 owner manual To change the access code, follow these steps

50 SmartLock (cont’d)

To change the access code, follow these steps.

1

Press the COMBI button, then press the MENU button.

> SMARTLOCK		PRESS B
	REVIEW
	EXIT
	PRIM. SETUP
	VCR PROGRAM
	VCR SETUP

2

Press the PLAY/▲ button or the STOP/▼ button to select SMARTLOCK. Then, press the F.FWD/B button.

SMARTLOCK

_ _ _ _

Enter Your Access Code

3

Use the Number buttons to enter your old access code.

The default code is 0711. If you have never set up your personal access code, use 0711 now.

After you enter the code, the SMARTLOCK menu will appear.

SMARTLOCK

X X X -

Enter Your Access Code

4

Press the PLAY/▲ button or the STOP/▼ button to select CHANGE CODE. Then, press the F.FWD/B button.

SMARTLOCK

BLOCK

>CHANGE CODE

SELECT KL CHOOSE B

TO END PRESS EXIT

5

Use the Number buttons to enter your desired access code in the New Code space. Then, enter the same code in the Confirm Code space.

Your new access code should be recorded. You will return to the SMARTLOCK menu.

New Code	_	_ _ _
Confirm Code	_	_ _ _

6

6 3,5

1	EJECT		POWER
	MENU	STATUS	CLEAR	FM
		/EXIT
	1	2		3
	4	5		6
	7	8		9
	SLEEP/			ALT.CH
	WAKE UP	0
	REC			PAUSE
	/OTR	PLAY		/STILL
	REW		F.FWD
		STOP
	CH.			VOL.
		MUTE
	CABLE	COMBI		SMART
	/DBS			PICTURE
		SPEED	MEMORY VCR PLUS+
	F.ADV		SLOW	ENTER

TRACKING VAR.SLOW

INDEXSKIP

SEARCH

2,4

Helpful Hints

•In order to protect the privacy of the access code, an X will appear on the screen instead of the num- ber you enter.

•If a “Wrong Code...” message appears on the screen after you complete step 5, you entered the wrong numbers in the Confirm Code space. Repeat step 5.

•You cannot use the default code after you set up your personal access code.

•If a power failure occurs, the default code, 0711, will be the active access code again.

•If you connect the power cord to an AC outlet that is controlled by a wall switch, your personal access code will be erased every time you turn off the power at the wall switch. The default code will be the active code again.

Press the STATUS/EXIT button.