Philips CCC194 Putting Batteries in the Remote Control, Battery Safety, Recording Prevention

Page 5

Before Using the TV/VCR 5

Putting Batteries in the Remote Control

1

Remove the battery compartment lid on the bottom of the remote control by pressing in the tab, then pulling up the lid.

2

Place two AA batteries inside the battery compartment

with their + and – ends aligned as indicated.

3

Replace the battery compartment lid.

Battery Safety

Battery Usage CAUTION - To prevent battery leakage that may result in bodily injury or damage to the unit:

Install ALL batteries correctly, with the + and - markings on the battery aligned as indicated on the unit;

Do not mix batteries, for example, old with new or carbon with alkaline; and

Remove batteries when the unit will not be used for a long time.

Recording Prevention

Video cassette tapes have record tabs to ensure you do not erase recordings accidentally.

1

2

3

1

To prevent accidental erasure, break off the tab with a screwdriver.

2

To record again, cover the hole with cellophane tape.

Using the Remote Control

Point the remote control at the TV/VCR’s remote sensor, then press the COMBI button when using the remote control to operate the TV/VCR. Point the remote control at the Cable Box/DBS, then press the CABLE/DBS button when using the remote control to operate the Cable Box/DBS.

Do not put objects between the remote control and the TV/VCR.

TV/VCR Maintenance

In this TV/VCR, use only tapes with the mark. The use of other tapes may result in poor picture quality and excessive deposits on the video heads, which may not be covered by the warranty if damage occurs.

Remove any light adhesive stick-on notes from the video cassette tape before putting the tape in the TV/VCR. Removable labels can jam the TV/VCR.

The TV/VCR requires periodic maintenance to maintain its excel- lent performance. This TV/VCR has an automatic head cleaning system. However, the video heads will eventually require cleaning or replacement. Only an authorized service center should perform this service.

1 2

Helpful Hints

Before doing anything else, record the TV/VCR’s model and serial num- bers in the spaces provided on page two. These numbers will help us assist you if you ever call for help.

Your new product, its packaging, and this manual contain materials that can be recycled and reused. Specialized companies can recycle your product to increase the amount of reusable materials and to minimize the amount that needs to be properly disposed.

Your product uses batteries that should not be thrown away when depleted but should be disposed of as small chemical waste.

Please find out about the local regula- tions on disposal of your old product, batteries, manual, and packaging when you replace existing equipment.

Image 5
Contents Color TV with built-in VCR For Customer Use Dear Philips product ownerThis bolt of lightning indi- cates uninsulated material Model No Serial NoSafety Precautions FeaturesIntroduction Declaration of ConformityTable of Contents Battery Safety Putting Batteries in the Remote ControlUsing the Remote Control TV/VCR MaintenanceHooking Up the TV/VCR Hook up your TV/VCR using one of the connections shownRF coaxial cable Not supplied Rod AntennaBent pin Hooking Up the TV/VCR cont’dCrooked Pin Straight Pin Cable PlugPress the Menu button. The screen shown below will appear Turning On the TV/VCRPress the Combi button, then press the Menu button Language SelectionWait for the TV/VCR to set up channels Automatic Channel SetupPress the PLAY/o button or the STOP/p button to select Adding/Deleting ChannelsRepeat steps 3-4 to add or delete other channels Programming of the last channel you selected will appearCable Box users must set the clock manually Setting the ClockManual Clock Setting Setting the Clock cont’d Automatic PBS Channel Selection Setting the Clock cont’dNOW Searching flashes on the TV/VCR screen Wait for the TV/VCR to findTime Manual PBS Channel Selection Wait for the TV/VCR to find the time Use the Number buttons to select your PBS stationDaylight-Savings Time Time Zone Find your code Setting the Remote to Operate a Cable Box/DBSFind the brand of your Cable Box/DBS on the lists below Remember the two-digit number beside itWithin 30 seconds, press the Number buttons to enter Repeat . If the remote control works your CableTwo-digit code for your Cable Box/DBS. For example, if You have a Zenith Cable Box, press Number buttons 0Front Panel Rear Panel AC Power CordANTenna Jack Connect your antenna or cable hereRemote Control Buttons Remote Control Buttons cont’d Adjusting the Picture Controls Decreased brightness Decrease IncreaseIf you select Status ON, then select Counter only OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only on If you select Status OFFInsert a tape in the TV/VCR PlayingFollow the steps below to play a tape Press the RECord/OTR button once to start recording Power button to turn on the TV/VCR, if necessaryRecording Press the STOP/EJECT but- ton on the TV/VCR to stop the OTR One-Touch RecordingDifferent brands of equipment may operate differently Rerecording Tape DuplicationFollow the steps below to prevent accidental recording Defeat RecordingDaily Timer RecordingTimer Recording cont’d Timer Recording cont’d Checking or Clearing Timer Recordings Station Setting Up the VCR Plus+ Programming SystemTV Channels Examine the lists on Setting Up the VCR Plus+ Programming System cont’dPLUS+/ENTER button You have completed the steps on pagesPress the Combi button, then press the VCR Timer Recording With the VCR Plus+ Programming System cont’d Appear on the screen Real-Time Counter MemoryTV programming will appear while the tape is rewinding Repeat PlayPress the PLAY/ button or the STOP/ button to select B Repeat PlayRepeat Play cont’d Forward and Reverse Searching SP/LP/SLP Playback OptionsSuper High Speed Searching LP/SLP Viewing a Still PictureBlue Background SmartLock Example Specific Sub-ratings SmartLock cont’dRatings are defined on Use the Number buttons to enter your old access code To change the access code, follow these stepsRating Explanations Press the Combi button, then press the SLEEP/WAKE UP button Sleep TimerWake Up Timer Example Closed CaptionMenu ScreenHalf-screen text Closed Caption cont’dStandard Closed Captions Usually, the volume bar appears when you press the VOLume Volume BarVolume Bar Automatic Operation Features SmartPicture TV ResetFM Radio Switching the AntennasReminder ReminderTape in the TV/VCR Index SearchHelpful Hints Helpful Hints cont’d Glossary Specifications Model # Serial # Limited WarrantyPlease contact Philips at French Speaking English Speaking Index Supplied Accessories Supplied Accessories