Philips DVDR3360H Direct recording from TV, Automatic recording from Satellite Receiver

Record to Hard Disk (continued)

Direct recording from TV

If you have connected this recorder to your TV using a scart cable, you can immediately start recording the programme (analogue TV channels only), which is currently being shown on the TV while the recorder is in standby mode.

A Ensure that the { Direct rec. } mode in the recording setting is turned on (see page 38).

B While watching the TV programme, press (RECORD) on the remote control to

start recording.

C To stop recording, press (STOP). Otherwise, it will stop automatically

after 6 (six) hours of recording.

Automatic recording from Satellite Receiver

The feature is only applicable for the Satellite Receiver (or any similar devices) that is connected to the EXT2 AUX-I/O scart socket of this recorder. In addition, the Satellite Receiver must have a timer function that is able to control the recording function of this recorder.

A Ensure that the { Sat record } mode in the recording setting is set to { EXT2 } (see page 38).

B Use the Satellite Receiver’s timer programming function to programme the recording (refer to the Satellite Receiver’s user manual).

You can only programme up to 6 (six) hours of recording.

C Leave the recorder and Satellite Receiver in standby mode for the recording.

You have to turn off the Satellite Receiver to standby mode before the recorder.

The recorder will start recording when it detects a signal from the Satellite Receiver.

Helpful Hint:

–The recorder’s timer recordings take

priority over automatic satellite recording. Automatic Satellite recording will stop if the recorder’s timer recording is due to start.

English

TIPS: Setting an appropriate recording mode is important as it determines the picture quality and recording time to the HDD or a recordable DVD, see page 38.

41