Philips DVDR3360H No sound, No TV signal received from the recorder, Message ‘NO SIGNAL’ appears

English

Troubleshooting (continued)

Problem (General)	Solution
No sound.	– Check the recorder audio connection. Read chapter “Basic
	Recorder Connections - Connecting the audio cables” for
	details.
	– Set the Analogue output or Digital output correctly, based on
	the device you have connected to this recorder. Read chapter
	“System Menu Options - Audio Output settings” for details.

No TV signal received from the recorder.

The message ‘Disc contains unknown data’ appears.

The message ‘NO SIGNAL’ appears.

–Have your aerial or cable TV signal checked.

–Install the TV channel. Read chapter “System Menu Options - Analogue Channel settings - Auto Search” for details.

–This message may appear if you insert a disc that was not finalised or contains junk data. DVD±Rs that have not been finalised are very sensitive to fingerprints, dust, or dirt. This may cause problems during recording. To use the disc again, do the following :

1)Make sure that the surface of the disc is clean.

2)Press OPEN/CLOSE on this recorder to open the disc tray.

3)Insert the disc but do not close the tray.

4)Hold down button number {5} on the remote control until the tray closes. This recorder will start the repair process.

5)If the disc is recovered, the Picture Index screen will appear.

Please observe the following:

–Error during recording : The title may be missing.

–Error while changing the title/index picture: The original title/ index picture may be visible.

–Error while finalising : The disc appears not to have been finalised.

–Check that the cable is plugged in firmly.

–If a recording is made from a video recorder, change the tracking on the video recorder.

–This recorder may not be able to recognise the video input signal if this signal is poor or does not comply with relevant standards.

‘X’ appears at the bottom of – No aerial signal received for the current channel or no video

the TV screen.signal received from the external input channel (EXT1, EXT2, CAM1 or CAM2).

–Check the antenna connection.

–Check the connection and turn on the connected device.

92