Philips 7819901511 manual To stop a timer-recording session, About the overlap of timer programs

Setting Timer Program (G-Code Mode)

There are two ways to set up timer programs using G-Code system. For more information on how to set up the system, see ‘Setting up the G-Code System’.

Path 1:

1.Press G-Codebutton to display the G-Code menu.

Path 2:

1.Press TIMER to display the Timer Record menu.

2.Press OK to start a new setting, or press  to select a previous setting which you would like to modify, then press OK.

3.Press  to go to the ‘G-Code’ button, then press OK to display the G-Code setup menu.

..........................................................................................

1.Press number buttons (0-9) or to enter the G-Code number, then press OK.

Timer_03_01

Details of the preset program will be displayed.

2.The ‘Preset Channel’ dialogue box will be displayed, if the DVD recorder fails to find information of a cor- responding channel. Press or number buttons (0-9) to enter the channel number shown on your TV, then press OK.

To make use of the G-Code system for timer record- ing, you need to match the GCNs (guide channel numbers) used by the G-Code system with the channel numbers shown on your TV, so that the relevant information can be correctly assigned to the programs you would like to record.

3.Set ‘Mode’ (recording mode) and ‘Repeat’ (recording frequency) for the timer program.

Press  to select one of the setting, then press OK to go to the sub-menu. Press to select, then press OK to confirm your selection.

4.Follow step 6-8 in ‘Setting Timer Program [Date/Time Mode]’ to complete the setting.

If you want to return to the Date/Time mode, press to select ‘Date/Time Setting’, then press OK. However, please note that all the settings you have entered will be cleared once you exit the present setup screen.

If you would like to delete a timer program set previously, go to Timer Record menu, highlight the bin icon located in the first column of the entry you want to delete, then press OK.

Notice for Timer Recording

1. To stop a timer-recording session:

Press STOP to cease the timer recording. Please note that it may take a few seconds before the program is completely brought to an end.

2.To check the recording status while ‘Timer Record’ is active:

Press DISPLAY to bring up the Timer Record informa- tion on screen.

3.About the overlap of timer programs

1.Each time after you complete and save the settings of a timer program, the DVD recorder will check if this program overlaps with other ones you set previously.

2.If the current timer program does overlap with one or more than one programs, a window asking if you would like to keep current setting will appear.

Timer_03_01

......

3.If you select ‘Yes’, the screen will go back to Timer Record menu. Under this circumstance, the later program takes priority, which means the DVD recorder stops recording the earlier program at the start time of the later program.

4.If you select ‘NO’, the screen will go to the setting page. You need to change or discard the setting of this program.

Timer Recording

29