Philips VRKD11YL, VRKD12BL warranty Helpful Hints cont’d

Page 39

Helpful Hints (cont’d) 39

Tape cannot be removed.

Make sure the power plug is completely connected to an AC (alternating current) outlet.

You have set a timer recording. Turn on the VCR power, then eject the tape. Be sure to insert a tape and turn off the VCR for your timer recording.

Tape cannot be inserted.

Insert the tape, window side up, with the record tab facing you.

Make sure a tape isn’t already in the VCR by pressing the STOP/EJECT button on the VCR.

Gently push on the center of the tape when putting it in the VCR. Never force the tape into the VCR.

If a timer recording is set, the VCR will not accept a tape that does not have a record tab. You may only insert a tape with the record tab intact.

VCR ejects the tape when the RECORD button is pressed or when the VCR power is turned off to set a timer recording.

• Make sure the tape has a record tab. Details are on page five.

There is no playback picture, or the playback picture is noisy or contains streaks.

Make sure the TV is on the same channel as the VCR’s CH3/CH4 switch. Details are on page seven.

Make sure the VCR is in VCR position. (The VCR/TV light will appear. If it does not, press the VCR/TV button once.)

Make sure channel 3 or 4 is properly adjusted.

Adjust the tracking. Details are on page 37.

TVs placed too close to the VCR can cause interference during tape playback. Move the VCR away from the TV.

TV programs cannot be watched normally.

Press the VCR/TV button to put the VCR in TV position. (The VCR/TV light will disappear.)

Check the connections between the VCR, TV, antenna/cable, and Cable Box/DBS (if applicable). Details are on pages seven-10.

The reception on all channels is poor.

• You may need to tune your TV again.

Line Input

If you accidentally enter Line Input mode (LineIn Rear (L1) will appear on your TV screen briefly), press the CHANNEL o/p buttons to select another channel.

The playback picture is too dim, too bright, or fluctuates in brightness.

Some programs may be broadcast with copyright protection technology in order to protect the rights of copyright owners. This technology is used on programs that are recorded on video tapes or Digital Video Discs (DVDs), as well as some programs broadcast by antenna/cable/satellite television channels. Programs broadcast with copyright protection technology may not record clearly. Likewise, if you play a tape that is a recording of a copyright protected program, the picture may not be clear. Tapes of copy- right protected programs may have a picture that is dark or dim, or the brightness of the picture may fluctuate. Therefore, you should avoid recording or playing copies of copyright protected programs. This VCR incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights own- ers. Use of this copyright protection technology must be authorized by Macrovision Corporation and is intended for home and other limited viewing uses only, unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

Image 39
Contents Instruction Book Model No Serial No Dear Philips product ownerFor Customer Use This bolt of lightning indi- cates uninsulated materialDeclaration of Conformity FeaturesSafety Precautions IntroductionTable of Contents Erasure Prevention Putting Batteries in the Remote ControlUsing the Remote Control Holder VCR maintenanceSetting the Time and the Alarm Using the Alarm ClockPutting Batteries in the Alarm Clock Using the Alarm Clock HolderDisconnect the antenna or cable from your TV Hookups Without a Cable Box / Direct Broadcast SystemCable Signal ConnectionsRecording/Viewing Any Channel Cable SignalRecording One Channel/Watching Another Cable Box/DBSHookups With a Stereo TV Turning on Your VCR Press the Menu button until the main menu appears Automatic TV Channel SetupAdding/Deleting Channels Automatic TV Channel Setup cont’dSetting the VCR Clock Your selection will flash on the screen in the AM/PM space Setting the VCR Clock cont’dChoosing a Language Press the EXIT/C. Reset button when you are finishedOFF mode Press the Display button once Count mode Press the Display button once Clock modeOn-Screen Displays Remote Control Buttons Power ButtonRecord Button Remote Control Buttons cont’d VCR/TV Light Alarm ClockPower Light Timer LightFront Panel Video OUT Jack AC Power CordBack Panel Audio OUT JackPlaying VHS Quasi Play Back SqpbRead and follow the steps below to play a tape 1Turn on the TV Insert a tape RecordingStopping an OTR Starting an OTRDetails are on page five Timer RecordingEnter the recording’s start time Repeat the procedure in to set the recording’s end timeTimer Recording cont’d Main menu will appear Cancelling a Timer RecordingCorrecting a Timer Recording To stop recording, press the Stop button VCR/TV light will disappearAntenna Rerecording Copying TapesRepeat Play Press the Play button or the Stop button repeatedly toSelect Auto Repeat Super High Speed Searching LP/SLP Forward and Reverse Searching/Pausing a PicturePausing a Picture Forward and Reverse Searching SP/LP/SLPPicture Select Press the Play button to watch the tape Real-Time Counter MemoryAutomatic Playback Features Helpful Hints Helpful Hints cont’d Renewed Dictionary/Specifications SpecificationsDictionary Index Supplied Accessories