Fisher-Price R1502 #10 Lock Nuts, Steering Column Upper Steering Lower SteeringLinkage

Page 12

ASSEMBLY

Handlebar

 

 

Handlebar

 

 

Neck

13

#10 Lock Nuts

Rounded

 

Side

Position the handlebar upright.

Fit the handlebar neck to the bottom of the handlebar.

Insert two #10 x 15/8" screws down through the handlebar and handlebar neck.

Fit a #10 lock nut onto the ends of both screws. Make sure the rounded side of the lock nut is down.

While holding a lock nut steady with an adjustable wrench (or pliers), tighten the screw. Repeat this procedure to tighten the other screw.

Set the handlebar assembly aside for assembly step 17.

Steering

Column

Upper Steering

Lower SteeringLinkage

Linkage

14

Bottom View

Hole

Lift the front end of the vehicle.

Slide the straight end of the steering column through the hole in the upper steering linkage and out through the hole in the vehicle.

Insert the curved end of the steering column into the hole in the lower steering linkage.

Steering

Column

Steering

Column Cap

15

Fit the steering column cap on the curved end of the steering column.

While supporting the steering column, insert a #8 x 3/4" screw into the hole in the steering column cap and tighten.

Hint: You may need the help of another adult to support the other end of the steering column while you insert and tighten the screw in the steering column cap.

• Lower the front end of the vehicle.

Steering Bushing

Steering

Column

16

Top View

Slide the steering bushing, narrow side down, onto the steering column and into the vehicle neck.

12

R1502a-0920

Image 12
Contents With Assembly Instructions Atableofofcontents Important InformationElectrical Hazard Parts HandlebarAtablepartsof Contents Atablepartsofpictureont NTS Parts Not ShownBattery Charging Please callAbatterytableofchargingcontents Assembly Rear Axle Motor Assembly Pins Rear Axle AssemblyRear Axle Lock Nut Washer Rear Wheel Driver Rib Hubcap 16 WasherMotor Assembly Hubcap Washer Rear Axle Lock Nut Assembly WrenchLock Nut Assembly Wrench Hub Cap CoverPull Vehicle Body UP Here Mo tor#10 Lock Nuts Steering Column Upper Steering Lower SteeringLinkageSteering Column Column Cap Steering Bushing ColumnSteering Column Handlebar Assembly #10 Lock Nut #10 x 3/4 Screw Rear VehicleFront Handlebar Cover Back Handlebar CoverAssemblydecoration GripDecoration Battery Installation Battery Care and Disposal CareTo disconnect the motor harness and battery connector Safe Driving RulesUse vehicle on generally level ground only Vehicle Operation ShifterVehicle Care Limited Warranty Bumper-to-Bumper Limited WarrantyProblems and Solutions Guide Problem Possible Cause SolutionDo not substitute parts Spin. If the other rear wheel does not begin to spin, there Before first-time use You must charge the battery Hours