Table 6. Remote configuration settings (“P” codes)
P Code | Digit(s) And Switch Equivalent | Value (1) |
P01 | B 0 0 0 0 0 0 0 0 | 0 |
| ↑ - - - - - - - |
|
| BUS A SETTING | 1 |
|
|
|
| B 0 0 0 0 0 0 0 0 | 0 |
| - ↑ - - - - - - |
|
| BUS B SETTING | 1 |
|
|
|
| B 0 0 0 0 0 0 0 0 | 0 |
| - - ↑ - - - - - |
|
| CAS SETTING | 1 |
| (E1 MUX ONLY) |
|
|
|
|
| B 0 0 0 0 0 0 0 0 | 00001 to 11000 |
| - - - ↑ ↑ ↑ ↑ ↑ | T1 Settings |
| TIMESLOT SELECTION | |
| T1/E1 |
|
|
| 00001 to 11111 |
|
| E1 Settings |
|
|
|
P02 | B 0 0 0 0 0 0 0 0 | From 0000 (0) |
| - - - - ↑ ↑ ↑ ↑ | to 1001 (9) |
| LOCAL CM ADDRESS |
|
| (HUNDREDS POSITION) |
|
|
|
|
| B 0 0 0 0 0 0 0 0 | … |
| ↑ ↑ ↑ ↑ - - - - |
|
|
|
|
P03 | B 0 0 0 0 0 0 0 0 | From 0000 (0) |
| ↑ ↑ ↑ ↑ - - - - | to 1001 (9) |
| LOCAL CM ADDRESS |
|
| (TENS POSITION) |
|
|
|
|
| B 0 0 0 0 0 0 0 0 | From 0000 (0) |
| - - - - ↑ ↑ ↑ ↑ | to 1001 (9) |
| LOCAL CM ADDRESS |
|
| (UNITS POSITION) |
|
|
|
|
Description
Bus A Disabled
Bus A Enabled
Bus B Disabled
Bus B Enabled
CAS Disabled for E1 MUX
CAS Enabled for E1 MUX
From left to right, these five bits represent the binary value of the desired time slot between 1 through 24 in a T1 network. See Table 4 for a complete list of these values.
From left to right, these five bits represent the binary value of the desired time slot between 1 through 31 in an E1 network. See Table 4 for a complete list of these values.
BCD Number (0 to 9)
Local CM Address, Hundreds Position
Not used
BCD Number (0 to 9)
Local CM Address, Tens Position
BCD Number (0 to 9)
Local CM Address, Units Position
>>table continues on next page <<
1.These are the only legal values for setting parameters. Setting a parameter to a value outside its specified range
will produce unpredictable results.
RFL NCM |
| RFL Electronics Inc. |
November 6, 2007 | 43 | (973) |